Advertisement
INSTALLATION
Note:
Electric Lift Kit (1692032) must be installed on 14GTG/
1. Install the upper hitch assembly (A, figure 1) to the rear
tractor frame using four spacers (B), washers (C) and
in the top frame holes and the rear capscrews are
mounted in the bottom frame holes as shown in figure 1.
2. Install the lower hitch assembly (E) to the tractor drawbar
nyloc nuts.
Secure the lower hitch brace to the rear frame using two
3. After the electric lift is installed, the lift rod (A, figure 2) will
be installed to the upper hitch as shown in figure 1 and to
the lift arm assembly using a clevis pin (6) and safety clip
(C) as shown in figure 2.
Note:
If tire chains are to be used for tiller operation, rear
wheels should be inverted for additional clearance between
RH wheeljchain and tiller Iii rod.
FIGURE 1. Rear Hitch
A. Upper Hitch Assembly
B. Spacers
C. Washers
D. Capscrews, 11'2-13 x 2 l/2"
E. Lower Hitch Assembly
F. Drawbar
G. Capscrews, 112-13 x 1 112"
H. Capscrews, 5/16-18x 1"
REAR ATTACHMENT HITCH
Rear hitch required for mounting tiller to 14GTG/
FIGURE 2. Electric Lift
A. Lift Rod
B. Clevis Pin
C. Safety Clip
INSTALLATION
INSTRUCTIONS
MFG. NO. 1692010
Form
1707679
Printed in USA
Advertisement
