Chamberlain ELITE EL2000BWCAMKT Manual

B/W, Color and Low Lux Color Cameras
for the EL2000 telephone entry/access control system
1 Disconnect power to the unit!
2 Unlock and open the unit.
3
Unplug the wire harness from LED board, remove and discard LED board. (3 screws) Keep "O" ring from old board and place on new board.
4 Replace black plastic lens with the clear
lens. Keep rubber "O" ring in place.
7 Plug the other end of the coaxial cable into a monitor or home entertainment system.
Reconnect the power to the EL2000 and the camera picture will appear.
NOTE: If the EL2000 is connected to a home entertainment system, the home entertainment
system must be switched to video input.
Install the camera module (3 screws). Reconnect the
5
LED board wire harness to the camera module.
LED Board
LED
Board
Wire
Harness
6
Model EL2000BWCAMKT
Model EL2000CCAMKT
Model EL2000DVRCAMKT
Caution!
A static discharge can
DAMAGE circuit boards.
Camera Module
Replaces the LED Board.
Feed coaxial cable (not provided)
through the conduit hole in the
back mounting plate of the EL2000.
Carefully connect a BNC coaxial
connector to the back of the
camera module. Close and lock
the unit.