Graco Mix 'N Move Instructions

Your new Graco
toy mounting system in the tray.
If your model includes Mix 'N Move
and you want to use them right away, follow
the instructions at right to install the toys.
If your model does not include the toys or
if you do not wish to use toys right away,
please follow the instructions below to
install the covers.
THIS PRODUCT REQUIRES ADULT ASSEMBLY.
Our goal is to make every product the best it can be!
We are also committed to supporting our products after
purchase. If you need replacement parts or would like
to speak to Graco about your product, please contact our
Customer Service Department at 1-800-345-4109
or visit our Internet website, www.gracobaby.com.

To Install Covers

If you are not installing Mix 'N
®
Move toys, you will need to use
the small covers found in your
hardware bag. To insert a cover
into the tray of your product, first
push one side into a notch, then
push in the other side.
© 2000 Graco 457-8-00
® product has a
®
toys
To Install Toys
(toy styles may vary)

Step 1.

If you have used a cover
previously, you will need
to remove it.
Remove child from product
before removing covers.
With the aid of a flat head
screwdriver, carefully pry up
one edge of a cover until it
comes off.
Throw the cover away
immediately; it is not reusable.

Step 2.

Insert the two prongs on the
toy base into a toy mount at
the notches.

Step 3.

Turn toy base 1 / turn until you feel
4
the toy snap into place. Check that
toy is firmly inserted by pulling on
the toy.
Toy is removable (turn it
the other way with a
little pressure) so that
you can replace it with
other toys when desired.