Advertisement
3.
Separate the junction box (1) and the
adapter plate (2).
4.
Unscrew the bubble assembly (3).
5.
Screw the cup base onto the swan neck
mount and tighten with the locking
screw, as shown below (A). Attach the
camera adapter plate to the cup base (B)
using screw A, route the camera cables
through the adapter plate.
6.
Route the camera cables through the
junction box, align the "FRONT" marks
located on the inside of the junction box
with the marking on the adapter plate,
and then secure the junction box to the
adapter plate by tightening the three torx
screws.
2 / 5
7.
Attach the safety lanyard and connect
the camera cables to the base of the
dome camera. Follow the instructions in
the dome installation guide to ensure the
IP67 rating.
8.
Install the camera body to the junction
box using the three torx screws located
in the dome housing, near the edge of
the housing. Reinstall the bubble
assembly.
To mount a dome camera to a TVD-
PPB pendant bracket with a TVD-CB7
cup base:
1.
Screw the pendant mounting plate onto
the pendant mount tube and tighten with
the locking screw, as shown.
2.
Route the camera cables through the
pendant mount. Attach the mount to the
ceiling using the expansion anchors that
are included with the pendant mount.
P/N 1073469-EN • REV A • ISS 24AUG18
Advertisement
