Sagem MyCK100 User Manual page 2

Volume cutting
wheel
Interface
Main push
button
Button 2
(Mute)
Charging MyCK100 handsfree kit
Note : Short press is an instantaneous press. Medium-long press is between 2 s
and 5s. Long press exceed 5s
Upon reception your handsfree kit is not charged. Before first use, you therefore need to recharge it
completely during approx. 8 hours using provided charger and charging adapter. Next recharge should
last approx. 2h 30 minutes.
If you hear 1 beep each minutes in your handsfree kit and light indicator flashes in red each 30 s,
handsfree kit needs to be recharged.
Please connect the charging adapter on one side to the handsfree kit and on the other side to the power
charger, which you can then connect into a mains plug.
Light indicator is red during charging process and turns blue after completion.
During the charge you can used your handsfree kit.
Please note use of any other charger will cancel the handsfree kit warranty. The handsfree kit shall
operate as normal during Charging Mode (such as receiving call, accept call etc).
To ensure a maximal life time to the battery, it is recommended to recharge the battery only when it gets
completely empty. Life cycle should allow approx. 500 charge & discharge cycles
If your handsfree kit is left with low battery for a long time, battery may get into overdischarge. In such
case, you may need to charge your battery during up to 10 hours before it recovers a full charge
Don't leave the charger connected to the headset more than 24 hours.
The MyCK100 handsfree kit has a protection in temperature activated during the charge. The charge will
be stopped under 0°C and over 55 °C in order to ensure a maximal life time to the battery
Microphone
cutting wheel
Button 1
(On/Off)
Button 1