Advertisement
Quick Links
AUTO SECURITY SYSTEM
MODEL : CR-3000
MANUAL FOR
USERS & INSTALLERS
Caution : Any changes or modifications in construction of this device which are not
expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
FCC statements
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
- 1 -
Advertisement
Summary of Contents for Crown CR-3000
- Page 1 AUTO SECURITY SYSTEM MODEL : CR-3000 MANUAL FOR USERS & INSTALLERS Caution : Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
- Page 2 CONTROL REMOTE 1. ARM 2. DISARM 3. MUTE 4. MUTE DISARM CRO WN CRO W N CRO WN CRO WN 1. ARM (LOCK) : Press #1 ( ) button 2. DISARM (UNLOCK) : Press #2 ( ) button. 3. MUTE ARM : Press #3(T) button, and Press #1 ( ) button.
- Page 3 CONTENTS a. Main brain with integrated double guard shock sensor b. Two remote controls ( transmitters) c. Harness with blade fuses d. 6-tone siren e. LED indicator f. Valet/ override switch g. Manual for users and installers FUNCTION PROGRAMMING BY INSTALLERS a.
- Page 4 PROGRAM OF TRANSMITTERS a. Turn ignition on and open a door first and then press Valet/Override switch 4 times (within 15 seconds), then LED will be on continuously and siren will emit 1 long chirp. You are now in the stage of programming mode.
- Page 5 a. Turn ignition on. b. Open the door. c. Press Valet/ Override switch for 3 seconds to enter valet mode (ignition valet) REMOTE PANIC a. Press and hold #4 for 3 seconds, the siren will sound and light will flash for 60 seconds. b.
- Page 6 sounds 1 chirp. 2) To exit valet mode, turn the ignition off and open the door, then press remote #4 button for 3 seconds until siren sounds 2 chirps. LED will be off. This indicates that system is on already valet mode.
- Page 7 CROWN Installation Diagram * Double Guard Shock Sensor (-)Horn: Additional relay(Programable) BAT12V HORN * Siren Output BAT12V WHITE WHITE BLACK 10PIN HARNESS * Starter Ground Output START LIGHT JUMPER MOTOR Ignition Key Valet SW Status LED BLUE Lock Output WHITE/BLACK...