Advertisement
Assembly Instructions
1. Install the (12) leveling screws.
Remove the router insert plate from the routertop, and
place the routertop face down, as shown. Using a power
drill, drive the screws in until they just come through the
other side. You will fine adjust them in step 8.
7 x 40mm
leveling
screw
2. Attach the (2) trim strips to the routertop.
Use the (4) small #6 x 1/2 screws. Use a Phillips
screwdriver and install by hand. Be careful not to over
tighten the screws. Do not use a power drill in this step!
The trim strips are purely decorative. Position the trim
strip as shown, and drive the screws into the bottom of the
routertop.
!
the bottom of the routertop!
3. Attach the routertop to your ProTop Cabinet.
Go to step 4 if you are building your own cabinet.
Use the (4) 1/4" round head bolts and (4) 1/4" cross
dowels. Always install the cross dowels first! The
drawing below shows how these strong but simple
fasteners fit together.
1/4-20"
cross dowel
1/4-20 x 2"
round head bolt
Install the leveling screws
into the (12) small holes.
Do not install them into
the two larger holes near
the other small holes.
Trim strips mount into
Panel
Cross Dowel
1
2
3
Bolt
Panel
Page 3
Advertisement
