Advertisement
Quick Links
Preparing the UXDS- - - - 1 Strobe for Use
Preparing the UXDS
1 Strobe for Use
Preparing the UXDS
Preparing the UXDS
1 Strobe for Use
1 Strobe for Use
Step 1
Battery installation
Battery installation
Battery installation
Battery installation
Unscrew the large knob giving access to the battery compartment.
You will feel some resistance as there are two O-rings providing positive protection against leakage.
Upon removal you can see the battery holder inside the compartment – slide this out
Step 2
Install four Double AA batteries in the holder paying close attention to polarity
(CAUTION : Installing batteries in WRONG polarities may cause heat to damage the battery holder and
the electronic components. Please install the batteries according to the polarity icons embossed on both
sides of the battery holder. Damage caused by incorrect battery installation is NOT covered under
warranty.)
Step 3
Following the position markings, snap the two Battery Holder Cover Plates onto both sides of the Battery
Holder
ULTRAMAX
ULTRAPOWER UXDS-1
UNDERWATER DIGITAL STROBE LIGHT
QUICK START GUIDE
Advertisement
Summary of Contents for Ultramax ULTRAPOWER UXDS-1
- Page 1 ULTRAMAX ULTRAPOWER UXDS-1 UNDERWATER DIGITAL STROBE LIGHT QUICK START GUIDE Preparing the UXDS Preparing the UXDS- - - - 1 Strobe for Use 1 Strobe for Use Preparing the UXDS Preparing the UXDS 1 Strobe for Use 1 Strobe for Use...
- Page 2 Step 4 Replace battery holder. (It can only be inserted when correct) Step 5 Replace cover and screw in firmly. Due to the double o-ring there will be resistance, make sure the knob is fully seated. Step 6 On/off switch On/off switch On/off switch On/off switch...
- Page 3 Step 7 Pre- - - - flash set flash set- - - - up. flash set flash set Your camera’s pre-flash may be set from zero pre-flash up to as many as four. To determine your camera’s setting, first turn on the Strobe. You will note the red LED is defaulted from the factory to the bottom light (0 positions).
- Page 4 Step 9 Test Test Test Test The yellow button allows you to test the strobe to assure it is functioning properly. When the Ready- Light is on simply press this button once. The Strobe will fire indicating it is fully functional. Ready &...
- Page 5 • Batteries (not included): 4AA Alkaline Battery ; Cycle Time: Approx 7~8 seconds • Rated Depth: 55M (183 Feet) • No. of Pre-Flash Settings : 5 • No. of Power Output Level Settings: 4 ( 10% > 25% > 50% > 100% ) ○ c 2010 ULTRAMAX Enterprises Inc. www.ultramaxincorp.com...