QuestLabs SGP-6000 User Manual page 8

* Note : finger-tighten the antenna.
2. Connect the handset cable to the phone jack and the handset
Plug the DC Adaptor cord into the power supply and an appropriate power outlet.
3. Check signal strength of the antenna icon and move the unit until you find the best signal possible.
2.3.6. Wall mounting
1. Drill two holes at the marked locations.
2. Tighten screws until the head is about 3~5mm from the
wall.
3. Hang SGP-6000 on the screw using two holes in the
back.
- 8 -
Rev 1.0 © QuestLabs Limited