Related Manuals for Vecima TRI2525B
Summary of Contents for Vecima TRI2525B
- Page 1 TRI2525B 2.5 – 2.6 GHZ SERIES BROADBAND WIRELESS TRANSCEIVER INSTALLATION AND OPERATION GUIDE...
- Page 2 Vecima Networks Inc. Vecima Networks Inc. reserves the right to revise this publication and to make changes in content from time to time without obligation on the part of Vecima Networks Inc. to provide notification of such revision or change.
- Page 3 Since 1988, our design powerhouse has created custom RF and digital products for technology leaders such as AT&T, Cisco Systems, Cogeco, Comcast and Cox Communications. All Vecima Networks products benefit from this ground-breaking expertise.
- Page 4 5. Le nettoyage - n'utilisez pas de nettoyeurs aérosols ou liquides. Utilisez un tissu humide pour nettoyer. Attention Ne pas travailler sur le système ni brancher ou débrancher les câbles pendant un orage du foudre. tri2525b_ml_03_sd Approved: G.V. Vecima Networks Inc.
-
Page 5: Table Of Contents
3.3 Resetting the Beeper ..............................16 4.0 WARRANTY AND SERVICE POLICIES ....................17 4.1 Warranty Statement..............................17 4.2 Service Policies: How to Return an Item for Service: .................... 17 4.3 Repair Charges and Warranty Exemptions......................18 tri2525b_ml_03_sd Approved: G.V. Vecima Networks Inc. - Page 6 Approved: G.V. Vecima Networks Inc.
-
Page 7: General Information
DOCSIS modem. The TRI2525B and antenna are situated outdoors and connected to a cable modem indoors by a low cost 75 ohm cable (i.e. RG-59, RG-6 or similar). A single RF F-connector on the weatherproofed enclosure provides the interface to the transmit/receive antenna for rapid installation. -
Page 8: Specifications
15° typical Antenna Compliance RSS193 Spurious Emissions RSS193 EMC Compliance RSS193 Dimensions 12” x 12” x 2.5” (305mm x 305mm x 64 mm) maximum Weight 7 lbs. (3.2 kg) Specifications subject to change without notice. tri2525b_ml_03_sd Approved: G.V. Vecima Networks Inc. -
Page 9: Installation
The active or desired polarization is the one in which the arrow points up. For example, when the TRI2525B is mounted on the pole, if the arrow pointing up on the back of the TRI2525B says “Horizontal Polarization” then the horizontal polarization is the active polarization. When the TRI2525B is mounted on the pole, if the arrow pointing up on the back of the TRI2525B says “Vertical Polarization”, the... - Page 10 : L-B IAGRAM RACKET RIENTATION Once the L-bracket is in place, the unit can be mounted to the pole. The pole catch, V-bolt and L- bracket are oriented as shown in Diagram 2.2B. tri2525b_ml_03_sd Approved: G.V. Vecima Networks Inc.
- Page 11 Horizontal Alignment Vertical Alignment STEP 2 – Position V-bolt and pole catch around pole To attach the TRI2525B to the pole, first position the pole catch over the threads of the V-bolt and hold against the pole with one hand. tri2525b_ml_03_sd Approved: G.V.
- Page 12 STEP 3 – Position TRI2525B against pole Using the other hand, bring the TRI2525B up to the pole catch and grab V-bolt, pole catch and L- bracket in a single hand. Ensure that the pole is inside the “L” of the L-bracket and not on the outside of the L.
-
Page 13: Connection To The Power Inserter And Cable Modem
Connections to the TRI2525B are made as shown in Diagrams 2.2B and 2.3A. Please note: 1) Connect the TRI2525B F-Connector to the power inserter, located indoors with the cable modem. The power inserter is then connected to the Cable Modem, only after the antenna is aligned. The... -
Page 14: Waterproofing Connections
6-inch length of rubber self-amalgamating sealing tape to use on the TRI2525B F-connector. Step 1 Use a 6” section of rubber sealing tape. Starting at the TRI2525B end, stretch the tape and wrap it around the connector as close as possible to the wall of the TRI2525B. Overlap the tape by approximately one-half of its width so that it can form a seal with itself. - Page 15 When done, the connection should be tightly wrapped with tape, with a good seal to the cable. tri2525b_ml_03_sd Approved: G.V. Vecima Networks Inc.
-
Page 16: Aligning The Antenna
TRI2525B. To use the aid, first mount the TRI2525B. If the unit is difficult to tilt or turn, loosen the locknuts on the V-bolts slightly. Apply power to the TRI2525B when you are ready to begin. The beeper will start sounding. -
Page 17: Warranty And Service Policies
Vecima Networks warrants its products to be free from defects in workmanship or materials for a period of two years. The warranty begins on the date of the original shipment from Vecima Networks to its customer. No claim may be allowed for expenses incurred in installation or use. No other expressed or implied warranties shall apply to the goods sold. -
Page 18: Repair Charges And Warranty Exemptions
Descriptions of these charges and warranty exemptions are below: 1) Repair turnaround time is typically 5-14 business days after receipt of the item at Vecima Networks. A Flat Rate Repair Charge will apply to all out-of-warranty items. Flat Rate Repair Charges are subject to change without notice. - Page 20 150 Cardinal Place Saskatoon, Saskatchewan, Canada S7L 6H7 Tel: (306) 955-7075 Fax: (306) 955-9919 Web: www.vecimanetworks.com Email: sales@vecimanetworks.com...