Electrical Connection (U.k. Only) - DeLonghi BBH200 Instructions Manual

Electrical connection (U.K. only)

A) Your appliance comes fitted with a plug, which incorporate a 13
Amp fuse. If it does not fit your socket, the plug should be cut
off from the mains lead, and on appropriate plug fitted, as below.
warning:Very carefully dispose of the cut off plug after removing
the fuse: do not insert in a 13 Amp socket elsewhere in the
house as this could cause a shock hazard.With alternative plugs
not incorporating a fuse, the circuit must be protected by a 15
Amp fuse. If the plug is a moulded-on type, the fuse cover must
be re-fitted when changing the fuse using a 13 Amp Asta
approved fuse to BS 1362. In the event of losing the fuse cover,
the plug must NOT be used until a replacement fuse cover can
be obtained from your nearest electrical dealer.The colour of
the correct replacement fuse cover is that as marked on the
base of the plug.
B) If your appliance is not fitted with a plug or if it must be
replaced, please follow the instructions provided below:
warning - this appliance must be
earthed
important
The wires in the mains lead are coloured in accordance with the
following code:
Green and yellow Earth
Blue Neutral
Brown Live
As the colours of the wires in the mains lead may not correspond
with the coloured markings identifying the terminals in your plug,
proceed as follows:
The green and yellow wire must be connected to the terminal in
the plug marked with the letter E or the earth symbol
coloured green or green and yellow.
The blue wire must be connected to the terminal marked with the
letter N or coloured black.
The brown wire must be connected to the terminal marked with
the letter L or coloured red.
E
L
N
Electronic Heating Convector BBH200
or