Advertisement
Advertisement
Table of Contents
Summary of Contents for Zonar EVIR 2010
- Page 2 (2) This device must accept any interference received, including interference that may cause undesired operation. Warning (Part 15.21) Caution: Any change or modification not expressly approved by Zonar Systems could void the user’s authority to operate the equipment. 19518 INTERNATIONAL BLVD.
-
Page 3: Table Of Contents
TABLE OF CONTENTS WHAT IT IS ..........................3 HOW THE SYSTEM WORKS....................3 WHY IT MATTERS ........................3 EQUIPMENT DESCRIPTION ....................4 KEYPAD & NAVIGATION ......................5 SCHEMATIC OVERVIEW......................6 HOW TO USE........................7-10 INDEX OF FUNCTION ......................11-12... - Page 4 LIMITED WARRANTY Zonar does not represent or warrant that the hardware and software are free of bugs or errors and shall not be liable for any losses (financial or non-financial) occurring as a result of such bugs or errors. No other warranty express or implied, including any warranties of merchantability or particular purpose, is provided for any hardware or software provided pursuant to this contract.
-
Page 5: What It Is
The Zonar 2010 Replaces Paper Forms For If you’re driving and stopped by a state trooper or Safety Inspections police officer, you’ll use the Zonar 2010 to provide on-road inspection verification. The Zonar 2010 replaces all the paperwork that’s Safety Inspection Information Stored In A... -
Page 6: Equipment Description
Info button for main UP arrow menu SELECT ITEM Light (for spotlights) button LEFT arrow RIGHT arrow Red N (no) button Power button for READ/ENTER button turning Zonar 2010 ON/OFF DOWN arrow Charging indicator Light Green Y (yes) button Power/Data Connector... -
Page 7: Keypad & Navigation
KEYPAD & NAVIGATION USE: Power button • Turn the Zonar 2010 on/off Info button • Return to the main menu at any time (except when you’re being prompted to enter a value or answer a question) READ/ENTER button • Read a card or tag •... -
Page 9: How To Use
• Press Info to go to main menu • Read the Asset tag - Position the Zonar 2010’s spotlights within 2 inches of Asset tag; press READ/ENTER button - Verify that vehicle number appears on screen - Enter vehicle’s mileage... - Page 10 Note: Holding the arrow buttons accelerates adding or decreasing increments. • Inspect all the components in a zone - Go to a zone (following the order you’ve been given) - Position the Zonar 2010’s spotlights within 2 inches of RFID tag - Press READ/ENTER - Inspect each component listed - Determine if each component is OK—no defects...
- Page 11 G, Y, or R WHEN: THEN: You’re ready to inspect the next zone • Go to the next zone • Position the Zonar 2010 within 2 inches of RFID tag; press READ/ENTER • Follow the directions above for inspecting a zone...
- Page 12 Note: While the Zonar 2010 is in its vehicle mount or RDS, the CHARGING indicator light will be a steady green. When the batteries are fully charged, the CHARGING light flashes green. While the time to fully charge the batteries varies depending upon the beginning battery level, it typically takes four hours to fully charge the batteries.
-
Page 13: Index Of Function
Press the red N (no) button Answer “Yes” to questions Press the green Y (yes) button Charge the batteries Place the Zonar 2010 into its vehicle mount, 10x charger or RDS Darken the text on screens • Highlight SET CONTRAST from main menu by scrolling the cursor with the DOWN arrow;... -
Page 14: Index Of Function
• Press READ/ENTER to set contrast Log in • Press READ/ENTER button • Place your Zonar ID Card within 2 inches of the Zonar 2010’s spotlights Read a RFID tag • Position the Zonar 2010’s spotlights within 2 inches of tag •...