General Advice - Cherry SmartTerminal ST-1275 Operating Manual

3 Using the chip card reader
3.1 Chip cards with contact
Insert the chip card into the chip card slot with the chip
facing upwards and towards the read head in the chip
card shaft.
After a discernable pressure point has been passed, con-
tact takes place.
3.2 Non-contact chip cards/transponders
Position the chip card or transponder as parallel to the
chip card reader as possible. (You can also insert the card
into the chip card reader.)
Data is transmitted beginning at a distance of less than
5 cm.
4 Disposal
Dispose of the old unit via a collecting point for
electronic scrap or via your dealer.
5 Contact
Cherry GmbH
Cherrystraße
91275 Auerbach
Germany
www.cherrcorp.com
www.cherry.de
Sales:
Phone: +49 (0) 1805 243779 (01805 CHERRY)
E-mail: sales@cherry.de
Technical support:
Phone: +49 (0) 1805 919108
E-mail: support@cherry.de
Please have the following information on hand when con-
tacting technical support:
• Item and serial no. of the product
• Name and manufacturer of your system
• Operating system and, if applicable, installed service
pack version
6

General advice

Cherry continuously optimizes products as new technologies
are developed. For this reason we reserve the right to make
technical alterations. The evaluation of product reliability and
the definition of the product's technical performance are
carried out according to Cherry's own requirements in order
to meet internationally recognized regulations and
standards. Requirements in addition to these can be met
through mutual cooperation. Improper usage, handling,
storage and external influences could lead to faults and
defects during use.
We do not accept warranty for defects caused by alterations
to our product by the user and shall not be held liable for
unauthorized modifications. All repairs must be made by
Cherry or an officially appointed organization or person.
Possible compensation claims against Cherry or its nomi-
nated officers – whatever the legal justification including
physical or stress related injuries – are excluded. Excep-
tions to this exist in the case of intent or gross negligence on
the part of Cherry, infringements of Product Liability Law or
in cases of injury, bodily harm or risk to health. These oper-
ating instructions only apply to the accompanying product.
Full details can be obtained from your local Cherry dealer or
direct from Cherry GmbH.
FCC:
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception,
which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more
of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for
help.
Canada:
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada
3