Table of Contents
Advertisement
Quick Links
MODEL GT-77 PARTS LIST
8/7/07
10:28 AM
Page 1
S U R E - F E E D
BROADCASTER
BROADCASTING, OPERATING and
MODEL GT-77
FOR ATV'S
HERD SEEDER COMPANY, INC.
P.O. Box 448 • 2383 South U.S. 35
Logansport, IN 46947
Phone: 574-753-6311 • Fax: 574-722-4106
Email: info@herdseeder.com
www.herdseeder.com
Instructions for
ASSEMBLY, MOUNTING,
MAINTENANCE
REPAIR PARTS LIST
Advertisement
Table of Contents
Related Manuals for Herd GT-77
Summary of Contents for Herd GT-77
- Page 1 MODEL GT-77 PARTS LIST 8/7/07 10:28 AM Page 1 S U R E - F E E D BROADCASTER Instructions for ASSEMBLY, MOUNTING, BROADCASTING, OPERATING and MAINTENANCE REPAIR PARTS LIST MODEL GT-77 FOR ATV’S HERD SEEDER COMPANY, INC. P.O. Box 448 • 2383 South U.S. 35 Logansport, IN 46947 Phone: 574-753-6311 •...
- Page 2 MODEL GT-77 PARTS LIST 8/7/07 10:29 AM Page 2 MODEL GT-77 For ATV’s WARNING SPINNING BLADES HAZARD To Prevent Serious Personal Injury or Death: KEEP HANDS, FEET AND CLOTH- ING AWAY FROM SPINNING BLADES. STAY CLEAR OF ALL MOVING PARTS WHEN IN OPERATION.
- Page 3 MODEL GT-77 PARTS LIST 8/7/07 10:29 AM Page 3 PARTS and ACCESSORIES FOR MODEL GT-77 BROADCASTER for A.T.V.’s Shown in Drawing When ordering parts, order by both part name and number ... not drawing number. Drawing Part Number Number Number...
- Page 4 Page 4 ASSEMBLY INSTRUCTIONS FOR ALL A.T.V.’S.: Take broadcast seeder GT-77 from carton and place it upside down on the hopper. Rotate handle around and remove bolt and self-locking nut. Run bolt through seed-gate linkage, then through the handle, making sure that the thread end is pointing up, toward you. Replace self-locking nut.
- Page 5 Replace pivot screw and bushing. Tighten but do not over-tighten. If it is over-tightened, end of screw will extend through pivot plate in bottom and block movement of opening plate. HERD SEEDER COMPANY, INC., LOGANSPORT, IN 46947...
- Page 6 Check ground, check fuse (this is a 20-amp fuse), check battery connections and battery, and then turn switch to “On” position. The unit should run if the motor is not damaged. For erratic spread of fertilizer or insecticides, check for lumps in material. HERD SEEDER COMPANY, INC., LOGANSPORT, IN 46947...
- Page 7 (Pelleted 45% 18’ 5/8” 4 Min. 35 Sec. Urea) 18’ 5/8” 2 Min. 35 Sec. CHART FOR BROADCASTING SEEDS AND FERTILIZER - MODEL GT-77 FIGURED AT 4 M.P.H. SIZE SOWS PER SEED OR MATERIAL OPENING ACRE WIDTH Ammonium Nitrate ........
- Page 8 Page 8 LIMITED WARRANTY This Herd Broadcaster was thoroughly tested before it left the factory. We warrant each Broadcaster sold by us to be free from defects in material and workmanship when used according to our directions. Our obligation under...
Need help?
Do you have a question about the GT-77 and is the answer not in the manual?
Questions and answers