Page 2
UNPACKING: After unpacking the unit, examine it for damage that may have occurred in transit. If the equipment has been damaged, do not attempt to install or operate it. File a claim immediately with the carrier stating the extent of the damage, or contact RadarFind customer service for repair or replacement.
Page 3
Contents of standard package: (1) - T10-B011 – A-Status Tag (1) TBA-3160 – Mounting Base (1) A12-1A0B – Adhesive Pad (2) A12-1T0B – Plastic mounting strap 12/28/2006 Radarfind Corporation— Phone 877 Radarfind—www.radarfind.com...
Page 4
Accessories A12-3T00 (2) Stainless steel mounting straps (for application of Radarfind tag mounting base (Part# TBA-3160) to tubular structures) Note: For best performance the steel straps require a special tool to tighten and cut the strap. 12/28/2006 Radarfind Corporation— Phone 877 Radarfind—www.radarfind.com...
Page 5
If the target location is not completely flat you may need to add strips under the ends of the adhesive pad (cut the strips from a spare pad) Building up adhesive to conform to curves 12/28/2006 Radarfind Corporation— Phone 877 Radarfind—www.radarfind.com...
Page 6
For best results mounting to tubular fixtures, such as IV poles or wheelchair frames, the locking base is equipped with strapping holes. These holes are designed to be used with thin stainless steel straps, available from Radarfind ( Part # A12-3T00 ) or Panduit: http://www.panduit.com/search/search_results.asp?Ne=1&recName=MLT1S%2DCP&N=5000001+336+3000858+®ion=USA Note: that the best results are obtained by using the strapping gun designed for these steel straps.
Page 7
Step # 3 – (Assuming that you have already entered your assets ) Select asset by entering the serial number or asset inventory number. Enter or scan tag ID into the Radarfind software, select which tag type, status or non-status, and hit <Tag!>...