Table of Contents
Advertisement
®
ABB Welcome
Wiring
Affix the bottom of the device and connect it according to the illustration. The insulated section of the cable end must not be longer than
0.39".
Settings
Set the addresses of the preferred outdoor stations and the addresses of the indoor stations on the jumper. (See Chapter 4.4, Adjusting
the device.)
Mounted on the wall
1.
Affix the bottom of the device to the wall.
2.
Latch the upper part of the device onto its bottom part. Place the upper side of the device on the lock-in lugs, and then press the
bottom side onto the bottom part of the device until the clamp catches.
Mounted with flush-mounted box
1.
Affix the bottom of the device to the existing flush-mounted box.
2.
Latch the upper part of the device onto its bottom part. Place the upper side of the device on the lock-in lugs, and then press the
bottom side onto the bottom part of the device until the clamp catches.
— 43 —
Advertisement
Table of Contents
