Airwalk 50CM PRO SLIDER Instruction Manual

Advertisement

Quick Links

Big
Wheel Slider Instruction Manual
 Thanks for your purchase. Please read this Owner's Manual completely before assembling or
operating this product.
 Assembly of this product should be carried out by an adult.
 Please ensure you follow the assembly instructions, as some parts must be installed before others.
 Not suitable for children under 8 years contains small parts.
 Always wear an approved safety helmet when riding. Always wear fully enclosed shoes.
 Never leave your child unattended on this product.
 Not permitted for use on public roads or highways.
 Don't use at night. Don't use on wet surfaces, uneven or unpaved roads.
 It is not recommended that slider is used on steep slopes or at high speed.
 Always check brakes before riding.
 Not designed for stunt riding.
 Max user weight : 80kgs
WARNING:
The product should be used with caution since skill is required to avoid falls or collisions
causing injury to the user or third parties.
Do not return this product to the store
!
If any parts are missing or damaged, please contact one of our Customer Service Representatives by phone on
1800 632 792(Australia)
0800 623 792(New Zealand)
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 50CM PRO SLIDER and is the answer not in the manual?

Questions and answers

Summary of Contents for Airwalk 50CM PRO SLIDER

  • Page 1 Wheel Slider Instruction Manual  Thanks for your purchase. Please read this Owner’s Manual completely before assembling or operating this product.  Assembly of this product should be carried out by an adult.  Please ensure you follow the assembly instructions, as some parts must be installed before others. ...
  • Page 2: Parts List

    PARTS LIST Part Description Quantit Main Frame Front fork Front wheel Handlebar Pedals 1 set Rear tube Rear axle Rear wheels Seat M6x30mm bolts and nuts 4 sets M6*21mm bolts M8x50mm Hex bolts and nuts 2 sets 8 washers and nuts 2 sets M8x65mm bolts...
  • Page 3 3. Assemble The Handlebar To The Stem Insert the handlebar (4) into the stem clamp and secure by tightening the four Allen Bolts. Ensure the bolts are tightened evenly. Disc Brakes If fitted with a front disc brake, the components should already be attached. However, please check all connections before attempting to ride the bicycle.
  • Page 4 Move the caliper arm approximately 1/8 of a turn anti-clockwise, or until pads almost make contact with the disc brake rotor and re-tighten the cable anchor bolt. 2. Use Allen key to adjust the regulator shifting pads to proper position. 3.
  • Page 5 WARNING: DISC GETS HOT! Severe injury could result from contact with the hot disc! Mind your legs, as well as your hands and don’t adjust directly after riding. 5.Test The Tightness Of The Stem Bolt And Handlebar Clamp Brace the front wheel between your knees and try to move the handlebars up and down and from side to side.
  • Page 6 8. Pedal Assembly Attach the pedals (5) to the crank and tighten with spanner or adjustable wrench CAUTION: There is a right pedal marked “R” and a left pedal marked “L”. Please ensure you assemble them on the correct side.
  • Page 7: Care And Maintenance

    Care and Maintenance Routine maintenance is an essential component of riding. The condition of your slider changes every time it is used, meaning more frequent maintenance is necessary the more you ride your slider. Please ensure you check all nuts and bolts are tight before each time your ride, and please check the brake before riding.

Table of Contents