Installation 1. Attach the black plastic mounting cup to the back of the nGauge 2. Plug the OBDII cable into the port located under the dash on the driver’s side. 3. Insert the other end of the OBDII cable into the rear of the nGauge. 4.
Page 3
Flashing a tune to your vehicle 1. Plug the nGauge into the OBDII Port located under the dash on the driver’s side. 2. Once the nGauge is plugged in and powered ON, select Tuning. 3. Select Load Tune. 4. Find the tune you wish to put on the truck. 5.
Page 4
Data-logging CCS tunes 1. From the home screen of the nGauge, select “Diagnostics” 2. Press “Datalogging” 3. Scroll to the option that applies to your vehicle then press the check mark to continue. 4. Press anywhere on the screen to begin Datalogging. A Yellow light will blink while data logging is in progress.
Page 5
Changing sleep/wake settings If you want to change when the nGauge shuts off or turns on: 1. Go to Diagnostics. 2. Select Settings 3. Select Sleep/Wake 4. Select Sleep Mode or Wake Mode to configure. How to configure the gauge display After connecting to your car, the nGauge should display 6 gauges.