Subscribe to Our Youtube Channel
Related Manuals for EVERSPRING AC124
Summary of Contents for EVERSPRING AC124
- Page 1 AC124 REMOTE CONTROLLER WITH LCD (compatible with U-net series) Device Number Keypad Button...
-
Page 2: Keypad Button
SYMBOL ON LCD SCREEN Symbol Name of Symbol Significance Antenna The remote controller is being communicated with other device. Signal The strength of RF signal in communication; it means communication failure if the symbol hasn¡t been shown. Not Applicable The setup made by the remote controller generates conflict. Battery Indicator full half to full... -
Page 3: Battery Indicator
INTRODUCTION With this multipurpose remote controller, you can easily and affordably enhance the comfort and security of your home or office. You¡ll see how easy it is to create a full custom system quickly that can remotely control lamps and appliances, without costly professional installation ¡... - Page 4 1-5 Learning Mode To enable the unit to control target devices, the prerequisite is to have it learned with each target device. Because the way of entering learning mode for each target device varies, refer to the instructions for each target device.
-
Page 5: Usb Interface
1-10 USB Interface The built-in USB interface is compatible with Everspring PC software. Scene and Schedule editing, RF device code learning, TV & DVD button learning, and time setting can be done via PC software. Note: Please switch the unit to RF mode before entering USB interface. Avoid the unit entering time setup, learning mode or scene/schedule setup while connecting USB interface to PC. - Page 6 device type -- and strength or single/tens digit button to select the of RF signal will be shown; the unit will device number that is to be cleared. The chosen return to step 2. Press to exit the learning device number and its corresponding type of , the chosen mode.
- Page 7 3-3 Editing Scene Setup 1. Press for 3 seconds until is flashing then release. is on steadily. If modification is required, follow the below steps for 2. Use or single/tens digit button to select the revision. scene number for which you plan to configure. 1.
- Page 8 4-1 Schedule Setup be modified) 6. Press again to enter day of week selection. Use Turn on the dim light and radio with soft music while to choose day of week as needed. going to bed at 9:00pm. When you fall asleep usually (Note: Keep pressing will return to step 3 for at 10:00pm, the dim light and radio will be turned off...
-
Page 9: Auto Mode
10. If including a scene number to schedule setup is needed, press will start flashing. The scene number will be on steadily if it is already included in the schedule, else scene number will be flashing. Use or single/tens digit button to choose one of the scene numbers. -
Page 10: Dvd Mode
Learning timeout period is 30 seconds. AC124 4. If learning fails, will be shown. Note: If button pressing is too long during learning process, IR signal will be repeated when using the unit to control TV (e.g. -
Page 11: Specifications
1. Press the button next to three times to switch the unit from RF mode to power setting mode. flashing implies that the unit is in power AC124 setting mode. Note: Normal power mode is default setting. 2. Press to set the unit in normal power mode ;... -
Page 12: Federal Communication Commission Interference Statement
Curtain Switch Rolling up Down Rolling down Stop Stop rolling Enter fully arm Alarm System Part-arm 1 Enter part-arm 1 Disarm Disarm Part-arm 2 Enter part-arm 2 Note: After the first button ( ) is pressed, then press Scene and schedule setup Type of Product Operation Command...
Need help?
Do you have a question about the AC124 and is the answer not in the manual?
Questions and answers