AlarmForce WS-7 Manual

Water sensor 315mhz

Advertisement

W
a
t
e
r
S
e
n
s
W
a
t
e
r
S
e
n
s
Water Sensor is specially designed to detect if the water level is above a certain level
that may damage your protected goods. It is a device that helps to manage your
protected place and goods by keeping it nice and dry.
I
I
.
.
P
P
O
O
W
W
E
E
R
R
:
:
The WATER SENSOR uses 4 AAA alkaline batteries as its power source. The battery is good
for at least 5 years before it needs changing.
The WATER SENSOR will only detect the low battery (< 3.6V) when an alarm has been
activated. The low battery signal will be sent to the Control Panel along with the alarm signal
transmission for the Control Panel to display the status accordingly.
I
I
I
I
.
.
G
G
E
E
T
T
T
T
I
I
N
N
G
G
S
S
T
T
A
A
R
R
Step 1:
Remove the cover by losing the two fixing screw on the top and bottom of
WATER SENSOR
Step 2:
Insert 4 AAA alkaline batteries in the battery compartment
Step 3:
Put the Control Panel into Learning Mode.
Step 4:
Press the Test Button on the Water Sensor, and a radio signal will be
transmitted to the Control Panel for learning.
Step 5:
Please refer to the panel's manual for checking the panel's response. If the water
sensor has not been learnt-in successfully, please repeat step 4 again.
Step 6:
Put the Control Panel back to standby mode.
Step 7:
The Learning-In process is now completed.
o
r
(
W
S
-
7
3
1
o
r
(
W
S
-
7
3
1
T
T
E
E
D
D
:
:
5
M
H
Z
)
5
M
H
Z
)
1
Test Button

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WS-7 and is the answer not in the manual?

Questions and answers

Summary of Contents for AlarmForce WS-7

  • Page 1 Water Sensor is specially designed to detect if the water level is above a certain level that may damage your protected goods. It is a device that helps to manage your protected place and goods by keeping it nice and dry. Test Button The WATER SENSOR uses 4 AAA alkaline batteries as its power source.
  • Page 2 The base has two knockouts, where the plastic is thinner for mounting purpose. To mount the SW-7: Remove the screw to separate the top cover from the base. Break through the two knockouts on the base where the plastic is thinner. III.

Table of Contents