Index Reset to Factory Defaults............... 2 Setting Symbology Parameters ............2 EAN....................2 UPC ....................3 Code 128 ..................3 Code 93 ..................4 ........5 Minimum and maximum length for Code 93 Codabar ..................6 ........7 Minimum and maximum length for Codabar Code 39 ..................
Reset to Factory Defaults Reset active configuration to factory defaults is set by scanning Option ZA, followed by scanning Option HD. ÉÁZA#Ë ÉÁHDoË Setting Symbology Parameters The LM500 Plus module is able to decode UPC-A, UPC-E, EAN-8, EAN-13, Code 39, Code 128, Code 93, Codabar, Interleaved 2 of 5, and Standard 2 of 5 symbologies.
Code 93 ÉÁUAÁË *Disable Code 93 ÉÁUBÄË Enabled Code 93 UEXX Set minimum length for Code 93 to XX UFXX Set maximum length for Code 93 to XX When Code 93 is enabled, label length defaults to UE01, Minimum length=1 character UF32 maximum length = 32 character...
Codabar ÉÁVAÃË *Disable Codabar ÉÁVBÆË Enable Codabar ÉÁVC!Ë *Disable transmission of start / stop characters ÉÁVD$Ë Enable transmission of start / stop as upper-case characters VEXX Set minimum length for Codabar to XX characters. Includes start / stop and check characters, if transmitted. VFXX Set maximum length for Codabar to XX character.
Interleaved 2 of 5 ÉÁPAvË *Disable Interleaved 2 of 5 ÉÁPByË Enable Interleaved 2 of 5 without a check digit. ÉÁPC|Ë Enable Interleaved 2 of 5 with a check digit PDXX Set minimum length for Interleaved 2 of 5 to XX characters. Includes check digit, if transmitted.
Standard 2 of 5 ÉÁPQ?Ë *Disable Standard 2 of 5 ÉÁPRBË Enable Standard 2 of 5 without a check digit. ÉÁPSEË Enable Standard 2 of 5 with a check digit. PTXX Set minimum length for Standard 2 of 5 to XX characters. PUXX Set maximum length for Standard 2 of 5 to XX characters.
Need help?
Do you have a question about the PiccoLink RF600 and is the answer not in the manual?
Questions and answers