Advertisement
Quick Links
Advertisement
Summary of Contents for Viatek Tapology! TAP01
- Page 1 DRAFT BEER SYSTEM USER MANUAL...
- Page 2 PLEASE READ WARNINGS AND INSTRUCTIONS THOROUGHLY BEFORE USING THE TAPOLOGY!™ FOR THE FIRST TIME. PLEASE NOTE: TAPOLOGY!™ WORKS WITH 12 OZ. CANS. *THERE ARE A FEW UNIQUE SHAPES OF 12 OZ. CANS THAT MAY NOT FIT. ALSO NOTE: UNIT SHOULD BE RUN WITH 12 OZ. OF WARM WATER WITH MILD DISH DETERGENT TO RINSE TUBING BEFORE FIRST USE WARNINGS: 1.
- Page 3 PARTS LIST: 1. Tap Handle 2. Pump Assembly 3. Main Body 4. Pedestal 5. Base...
- Page 4 INSTRUCTIONS: 1. Turn the Pump Assembly counterclockwise from the Main Body and lift up.
- Page 5 2. Open the battery cover by twisting the screw counterclockwise. Place two AA batteries into the compartment as shown. Replace the battery cover and screw down tight.
- Page 6 3. To open the Tapology!™, hold the Base and twist the Main Body counterclockwise and pull up.
- Page 7 4. The Tapology!™ only supports 12 oz. cans of beer. Line up the 350ml marking on the pedestal with the notch located on inside of base for 12 oz. cans. The 330ml marking only applies to some import beverages and does not work with standard American beverage can sizes.
- Page 8 5. Open your beverage and place onto the Pedestal. Make sure the opening of the can faces towards the front of the Base. Feed the silicone tube into the opening in the can and then slide the Main Body over the beverage and onto the Base. Once you have it on the Base, match the line on the Main Body to the dot on the Base and turn clockwise until both lines are aligned and parts are securely attached.
- Page 9 6. Either hold your cup or place on the grill of the Base and pull the Tap Handle towards you to start the flow. It is best to use a pilsner, pint glass, or Arctica™ Party Cup with the Tapology!™. When the cup is mostly full, you can push back on the Tap Handle to create the amount of foam that you desire on your beer.
-
Page 10: Cleaning And Maintenance
CLEANING AND MAINTENANCE: • Rinse out empty beer can. Fill with hot water and follow steps 3-5 to run water through unit to clean. Remove can when complete. If needed, mild dish detergent can be used. Unit should be flushed with clean water afterwards. •... - Page 11 2. Attach longer tube to tube connector and feed back through hole into the Main Body. 3. Gently push tube connector into place to secure.
- Page 12 DO NOT DISPOSE OF BATTERIES IN FIRE. ALWAYS DISPOSE OF BATTERIES PER LOCAL & FEDERAL GUIDELINES. © 2017 VIATEK CONSUMER PRODUCTS GROUP, INC. All speci cations are subject to change without notice. All rights reserved. Viatek Consumer Products Group, Inc. 6011 Century Oaks Dr. Chattanooga, TN 37416...