Advertisement
Table of Contents
ActiveLot OBD Module User's Guide
Overview
The ActiveLot OBD Module gathers information from the vehicle along with the GPS location
and transmits it back to the ActiveLot system. While the vehicle is running, it will transmit
once every five seconds. While the vehicle is off, it will initiate a transmission cycle once
every hour.
For help with installation procedures, or if you have any questions, contact:
This device complies with part 15 of FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Confidential & Proprietary Information of KeyTrak, Inc. © 2014
KeyTrak Support
1-800-541-5033
FCC Warnings
1
Advertisement
Table of Contents
Summary of Contents for Keytrak ActiveLot
- Page 1 The ActiveLot OBD Module gathers information from the vehicle along with the GPS location and transmits it back to the ActiveLot system. While the vehicle is running, it will transmit once every five seconds. While the vehicle is off, it will initiate a transmission cycle once every hour.
- Page 2 Insert the OBD module into the OBD-II port on your vehicle. Start the vehicle. This is required to pull the VIN (vehicle identification number) from the vehicle’s computer system. You can verify the unit is transmitting using the ActiveLot iOS app, the Web app, or the KeyTrak application. NOTE: A couple of minutes after installation, the OBD module will acquire the necessary GPS satellite information to provide an accurate location.
Need help?
Do you have a question about the ActiveLot and is the answer not in the manual?
Questions and answers