Advertisement
Quick Links
Aqua-Rita Table™ Installation Instructions
Installing the Aqua-Rita Table™ is simple and does not require any tools for
proper assembly. You're too busy to be messing around with confusing
instruction manuals – you have a pool to be in!
WARNING: NO DIVING or JUMPING off of the Aqua-Rita Table™!
1. Place all 4 seat holders in upright position with all the dovetails facing
each other forming a square.
Advertisement
Summary of Contents for Aqua-Rita Table
- Page 1 Aqua-Rita Table™ Installation Instructions Installing the Aqua-Rita Table™ is simple and does not require any tools for proper assembly. You’re too busy to be messing around with confusing instruction manuals – you have a pool to be in! WARNING: NO DIVING or JUMPING off of the Aqua-Rita Table™! 1.
- Page 2 2. Slide the center post into each dovetail at the same time securing it all the way in. Make sure the center post is all the way down, locking in all 4 seat holders so the center post cannot move side to side. (If necessary, use one of the seats to tap center post all the way down) 3.
- Page 3 7. Locate the small threaded end of threaded post and screw it COUNTER CLOCKWISE into the bottom of the table top. Tighten all the way down. Be sure hole in table top lines up with seam line on threaded post.
- Page 4 Take a 5 minute break, put on a swimsuit, and grab a friend! 10. Place the table top, the drain plug cap, and your drink next to the pool. 11. Jump into pool. Move base to desired location and make sure it is filled with water.
- Page 5 MUST be 6-8 inches above water which is where the bottom curve starts. The weight of the table top keeps the base from floating. 16. Hand tighten both hand screws on center post to lock in desired table height. 17. Relax and let the PARTY begin.