Auto-Pyjama PermaBag Manual

PermaBag® for outdoor use complete with:
Auto-Storm® Top Cover for extra padding
•
Silver Cover for outdoor weather protection
•
PermaPack® moisture absorbing cylinders
•
Digital Thermo-Hygrometer
•
Set of Storm-Straps
•
Brass lock for PermaBag
•
1. Choose a dry day with low humidity. A sunny dry day will accelerate the drying procedure.
2. Check that engine and exhaust are cool.
3. Check that car mats are dry and no perishable food is inside the car.
4. Check all rubber hoses and connectors, giving special attention to fuel lines, fuel tank and water
hoses such as the cooling system, wiper system, fuel system.
5. Remove tools and all private belongings.
6. To prevent odours a packet of Bicarbonate of Soda may be placed inside the car.
Do not use mothballs or any other toxic products.
7. Open side windows and retract or remove antennas.
8. Choose a suitable location, if possible protected from wind, storm and sun. The ground should be
non-porous and firm such as asphalt, gravel or cement. Do not park on earth, grass or sand!
9. Make sure the ground is free from all types of sharp objects prior to proceeding. Installation:
10. Lay the 3 Storm Straps on to the ground where the car is to be parked (see Picture 1 on reverse side)
11. Lay the PermaBag (zip still closed) on top of the three straps. All 6 ends of the 3 straps should be
visible. Unzip PermaBag and unfold. The three straps should be located underneath the section
with the yellow patch. The yellow patch should now be visible at the front left-hand corner.
12. Push the car on to the material so that the yellow patch is level with the front left-hand corner of
the car. Cabriolet cars must have their soft top up in order to prevent a puddle from accumulating!
13. If TireShoes are to be used these should now be placed underneath the tyres.
14. Place some form of oil-spill protection underneath the engine if necessary.
15. Now place the grey Auto-Storm
PermaBag
For outdoor use
D i r e c t i o n s
®
Top-Cover on to the car.
- 2 -
®