Tel. 059 469 978 - Fax 059 468 874 www.kernelgroup.it WARNING : The Kernel Sistemi s.r.l. reserves the right to modify at any time the content of this document, without prior notice to Customers following any changes or revisions. INDEX 1 HARDWARE CHARACTERISTICS............3...
Digital Outputs Analog Outputs 1 Serial Line : RS 485 Serial Lines Supports the communication protocols : KERNEL, KNP and MODBUS RTU Leds 2 red leds for communication signalling Addressing 8 Dip-switches (of which only 5 for the addressing from 1 to 31) 1.2 Mechanics Characteristics...
Kernel Sistemi s.r.l. 1.3 Dimensions Front View 24x101 ; Depth 119 mm 1.4 Strain gauge resolution Is possible change the strain gauge resolution (in according to the model) with the two dedicated dip-switches, look following image : DLC 1200SG – User Manual...
Here are some examples that help to understand : In the application program of the PLC of the Kernel Sistemi you need to set the NUMBER and the TYPE of EXPANSIONS that are connected. To do this it's necessary to open the project and go into the menu "Project Options"...
PLC project and go to the menu "Project Options" >> table "Serial" to select the correct protocol : DIP-SWITCH 1 e 2 - Project Options >> “Serials” of the PLC project ------------------------------------------------------------------------------------- 00 = KNP (Kernel Network Protocol) – KNP MASTER 01 = KERNEL Protocol - KERNEL 11 = MODBUS RTU Protocol - RTU MASTER Also the Baud Rate set with the dip-switch must obviously coincide with the one selected in the "Project Options"...