Omega Post-Type Wall Mount Shelving Assembly Instructions page 2

ASSEMBLY INSTRUCTIONS
Step 10 Secure the post mount brackets by gently hitting them with a rubber mallet or using a hammer and
block of wood. (See Diagram #3) Never use a hammer directly on the bracket without using a block of
wood to protect the unit.
Step 11 Assemble an end bracket to each corresponding mounting hole location. Be certain to have the back
leg on the end brackets facing downward. Tighten hardware only until snug.
Step 12 Take a post assembly and position it between the two end brackets. At each end of the post, assemble a
bolt (previously removed from the post) through the end bracket and into the post. Tighten the
mounting hardware for the end brackets and the bolts for the posts completely.
Step 13 Attach the intermediate bracket(s) to each of the corresponding mounting holes (where applicable,
depending on the unit being mounted).
Step 14 Repeat steps 12 and 13 for the remaining post assembly
Step 15 Mount the shelf or shelves by positioning the corner collars on the shelf or shelves over the retaining
loops of the post mount brackets. (See Diagram #4)
Step 16 Insert the chrome plated shelf caps into the corner collars of the shelf or shelves.
THIS COMPLETES THE ASSEMBLY OF THE UNIT
DIAgRAM 3
Call Customer Service at 1-800-221-8665 | Fax 631-563-5041
DIAgRAM 4
www.precisiontools.com
rev. 0311