TDE MACNO 374T000600V User Manual

Remotable display/keypad for opd exp and mini-opd exp drives

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

Accessories Tde Macno

User's Manual

Remote Keypad

Table of Contents

Need help?

Do you have a question about the 374T000600V and is the answer not in the manual?

Questions and answers

Summary of Contents for TDE MACNO 374T000600V

Page 1 Accessories Tde Macno User’s Manual Remote Keypad...
Page 3: Table Of Contents
INDEX INTRODUCTION ..................2 SPECIFICATIONS .................. 2 ENVIRONMENTAL SPECIFICATIONS ..........3 DIMENSION DRAWINGS ............... 3 ORDERING INFORMATION ..............4 CONNECTIONS ..................4 INTERFACE ADAPTERS ............... 6 PANEL MOUNTING ................
Page 4: Introduction
1 INTRODUCTION The 374T000600V is a remotable display/keypad for OPD EXP and mini-OPD EXP drives. The reliable RS485 industrial standard interface allow the keypad to be remotated up to several hundred meters. It implements a Modbus RTU protocol and behaves like a master on the RS485 bus with the possibility to connect to several slave drives selecting the active drive (one at a time) by node address and bitrate.
Page 5: Environmental Specifications
Custom/extended operator interface (available for direct management by drive's application) Application custom keys 3 keys Application custom indicators 4 + 2 leds (3 yellow, 2 green, 1 red) Advanced features Non Volatile storage memory flash type, 2 MByte NV memory functions ...
Page 6: Ordering Information
5 ORDERING INFORMATION 374T000600V remote keypad + 1.8m serial cable (DB9F-DB9M) external adapter for OPD EXP remote keypad interface (to free drive’s main RS485 374I00100V interface) dummy keypad board adapter for mini-OPD EXP (to free drive’s main RS485 374I00090V interface)
Page 7 For “long” and/or multidrop connection is also mandatory to connect the polarization/termination networks both on the first and last device on the bus chain: to do so, the pin 5 have to be tied with pin 2 (2 and 3 if the device is a drive) and the pin 9 have to be tied with pin 6 (6 and 7 if the device is a drive). Shielded cable with twisted pairs (min AWG 22) is also recommended To enhance EMI noise immunity, when remote keypad is used with mini-OPD EXP,...
Page 8: Interface Adapters
Supply voltage has very wide input range (see specifications) and the keypad is protected against polarity reversal. The builtin DC-DC regulator (switching type) assures high efficiency and almost constant power comsumption over the whole voltage range Please notice that THERE IS NOT ISOLATION between power supply and the RS485 interface, so take care during installation to avoid voltage contentions and ground loops.
Page 9: Panel Mounting
For OPD EXP it is an external adapter that connects to the “remote keypad” interface in the front panel of the drive (the integrated keypad is switched off when the adapter is inserted: only one segment will remain lit up to signal that the drive has power supply).
Page 10: Beyond Legacy Display Limitations
The Operator Interface is almost the same available by the keypad integrated into the OPD EXP or mini- OPD EXP drives, with same menus and navigation/editation key sequences and combinations (please refer to the drive User Manual for further information about the standard operator interface). Note that the operator Interface of the drive is available only when there is communication between remote keypad and the drive.
Page 11: Menu Flb (Fieldbus Parameters)
Name Description Default Notes L.00 slave address to query 0 → BUS IDLE 0 = 19.2kbps, 1 = 38.4kbps, 2= L.01 bitrate 57.6kbps, 3 = 115.2kbps L.02 save to NVM L.03 reload from NVM L.04 load defaults setup for drive 2nd RS485 L.05 equal to set L.00 = 1, L.01 = 1 interface...
Page 12 F.11 IP_ADDR_03 Anybus IP Address 03 F.12 SUBNET_MASK_00 Anybus Subnet Mask 00 F.13 SUBNET_MASK_01 Anybus Subnet Mask 01 F.14 SUBNET_MASK_02 Anybus Subnet Mask 02 F.15 SUBNET_MASK_03 Anybus Subnet Mask 03 F.16 GATEWAY_00 Anybus Gateway 00 F.17 GATEWAY_01 Anybus Gateway 01 F.18 GATEWAY_02 Anybus Gateway 02...
Page 13: Extension Of Menu App
F.46 TX0_SUB_INDEX Transmit Object0 Sub-Index 0000 FFFF 0000 F.47 TX1_INDEX Transmit Object1 Index 0000 FFFF 0000 F.48 TX1_SUB_INDEX Transmit Object1 Sub-Index 0000 FFFF 0000 F.49 TX2_INDEX Transmit Object2 Index 0000 FFFF 0000 F.50 TX2_SUB_INDEX Transmit Object2 Sub-Index 0000 FFFF 0000 F.51 TX3_INDEX Transmit Object3 Index...
Page 14: Additional Custom Keys And Leds
Menu APP: application parameters OPD Explorer OPD Explorer Name Default name description E.00 E.99 Notes: (1) – depends on installed application Menu APP: application extra parameters OPD Explorer OPD Explorer Name Default name description E.100 0000 FFFF 0000 FFFF E.599 0000 FFFF Notes: (1) –...
Page 16 s.p.a. tecnologie digitali elettroniche Via dell’Oreficeria, 41 36100 Vicenza - Italy Tel +39 0444 343555 Fax +39 0444 343509 www.tdemacno.com...