structura Duo Bollard Installation Instructions

Duo Bollard
Installation Instructions

Warnings

CAUTION—risk of fire and this product must
be installed in accordance with the applicable
installation code by a person familiar with the
construction and operation of the product and the
hazards involved.
Suitable for wet locations.
LED Module
Mounting orientation must have light source facing
down.
Electrical service must be disconnected during
installation.
Proper grounding is required to protect against
shock and proper operation.

Tools Required

T20 Tamper-resistant drive for panel screws
9/16" socket or wrench for anchor bolts
Philips drive for driver box lid
Wiring tools and connectors

Bollard Installation

Step 1: Remove (4) 8-32 tamper-resistant torx screws
from from lower accent panel. Set panel aside.
Driver Box
Step 2: Pull driver box out of bollard base and
connect power to LED driver. See page 2 for driver
box wiring.
Step 3: Set bollard on to pre-installed anchor bolts.
Make sure baseplate is level.
Step 4: Secure bollard with supplied (4) 3/8"-16 nuts
and washers.
Step 5: Place driver box back into base cavity.
Step 6: Resecure accent panel.
Accent Panel
8-32 Tamper-Resistant Torx
3/8"-16 Nut
19922 W. 162nd St., Olathe, KS 66062 913.390.8787 www.structura.com