Advertisement
Box Contents
SYSTEM OVERVIEW
INTRODUCTION
If your Wyse.ly system has more than 32 battery-powered devices, alongside
the AC10RF ZigBee coordinator you must add an AE10RF ZigBee repeater.
You must also add an AE10RF repeater if the battery-powered devices in your
iT600 Wyse.ly are too far away from the mains-powered devices.
1 x Installer / User manual
1 x AE10RF
1 x Plug Adapter
For PDF Installation guide go to
www.salusna.com
INSTALLATION
1
Plug
Plug the repeater
2
into the adaptor.
Plug in the coordinator as
3
described in the Coordinator
Instruction Manual. All device
pairing is done through the
coordinator.
Press and hold the button on
4
the Coordinator for five seconds
to enter pairing mode. The LED
flashes red.
Repeater
Plug the repeater into the120V
5
POwer outlet. The button flashes
red.
Refer to individual device
manuals for more information.
AE10RF
The ZigBee repeater must be used with
the RF range of the products below:
Wyse.ly System
AKL08RF
AC10RF
AX10RF
Press and release the repeater
6
button. The LED goes solid red
to show it is connected to the
network.
The system installation is now
7
complete. Press and hold the
button on the Coordinator for
five seconds to close pairing
mode. The LED goes solid red.
Also refer to the coordinator
and individual device manuals.
AS20RF
Thermostat
ARV10RFM
Advertisement
