Advertisement
Handle Installation
1.
Install handle onto stem in desired "off"
position.
2.
Confirm handle is not binding with
escutcheon. Adjust valve nuts and
escutcheon if necessary.
3.
Handles are fastened with a set screw or
top screw.
4.
If set screw type: install washer and
screw, tighten then press in decorative
cap with o-ring.
A
5.
If top screw type: install washer and
screw, tighten then press in decorative
cap with o-ring.
Drain Assembly
1.
Disassemble top flange (2) and drain stopper (1)
from pop-up drain body (6).
2.
Loosen mounting nut (5) for desired height.
*Note: This may vary depending on thickness of
9/16"
sink basin or countertop.*
3.
Apply appropiate silicon/putty under lip of top
flange (2).
4.
From underneath, insert drain body (6) through
sink basin or countertop and attach top flange (2).
5.
Guide sink gasket (3) & plastic washer (4) up snug
to bottom of sink basin or countertop.
6.
Test the length needed for drain stopper (1) by
8
adjusting height of eyelet so it is visible from side
port of ball rod.
7.
Align top flange (2) & drain body (6) & tighten nut
(5) securely.
COMPONENT PARTS
8.
Test alignment using ball rod (10) without ball rod
seats (8) to ensure it goes through eyelet of drain
stopper (1).
9.
Adjust length of drain stopper (1) (if required) by
loosening the nut & eyelet to desired height. Then
secure back up to bottom of drain stopper (1).
10. Put one ball rod seat (8) before ball in ball rod (10)
concave side toward ball. Push through side port
making sure the ball rod (10) goes through drain
stopper (1) eyelet. Put second seat (8) on+to other
side of ball rod (10) & attach ball rod nut (9). Do
not over tighten.
11. Pushing ball rod (10) down to raise drain stopper
(1) in sink. Test & adjust if necessary.
12. Attach lift rod strap (11) to pop-up rod.
13. Push down on ball rod (10) putting one
end of spring clip (12) on, then put through
appropiate hole in lift rod strap (11). Attach other
end of spring clip (12) & test.
14. Attach tailpiece (7) to drain body (6) using pipe
thread sealing tape on threads.
8.17.2017
JACLO.COM
| PG 4
12
15
13
11
5
FIGURE 6
14
10
12
8
14
6
8
10
9
j a c l o i n d u s t r i e s | 129 Dermody Street Cranford, NJ 07016
p 908.653.4433 | 800.852.3906
1 ½"Ø
3
13
7
15
10
COMPONENT PARTS
11
f 908.653.1717 | 800.852.4133
2
1
4
1
2
3
5
6
7
Advertisement
