Battery Replacement; Mounting - Vaultek Smart Key NANO Instruction Manual

BATTERY REPLACEMENT

When Smart Key Nano LED flashes red (3)
times that indicates a low battery. Replace the
battery per steps below:
1
Twist base of Smart Key counter clockwise to
access battery compartment.
2
Remove old battery and install a new
CR2032 battery.
3 Assemble Smart Key
is not required.
12 Vaultek
®
back together, re-pairing

MOUNTING

The mountable base comes with double-sided
tape allowing for quick and easy installation.
Simply peel off the protective layer on the
reverse side of the base, and place where
desired.
Tip!
Before installing your mountable base, clean
the mounting area to ensure surface is dry for
proper adhesion.