Page 2
STEP 1—GETTING STARTED... INSTALL THE BATTERY To open the Battery Snap in negative (-) battery Compartment, slide finger nail terminal first, then positive (+). under compartment edge and Route wires to right side as release the latch. Use a 9 Volt shown, insert battery and close.
STEP 2—DESCRIPTION OF CONTROLS Start Settings: • Intensity Dial at “0” • Power Switch to “On” • Polarity to “Normal” • Pulse Width to “150”...
Page 4
STEP 3—GET ACQUAINTED WITH THE FEEL OF THERAPY Moisten the palm of the hand with clean tap water using a moist towel. Place the device on the palm of the hand and slowly increase intensity from “0” to the highest comfortable setting.
Page 5
STEP 5—MOISTEN SKIN OR APPLY GEL Moisten the skin in the area of pain with gel or clean tap water using a moist towel. (Apply a small amount of “Spectra 360 Gel” as needed. Water alone provides good conduction for most users.) STEP 6—APPLY THERAPY TO PAIN Place the device over the most...
Page 6
STEP 7—APPLYING THERAPY TO LARGER PAIN AREAS A: If the pain area is larger than ¾ B: Continue to change positions inch, repeat Step 6 by positioning across the pain area to provide the device to the left and to the therapy to the entire area.
HELPFUL HINTS • The treatment time varies with the level of pain and will vary from person to person. • Always press while holding and do not set the Intensity higher than is comfortable for you. Higher Intensity levels will normally shorten treatment time but comfort during treatment is highly important.
Page 8
5 SECRETS FOR SUCCESSFUL PAIN RELIEF 1. ALWAYS PRESET THE INTENSITY CONTROL TO ZERO BEFORE AND AFTER USING Before pressing Solis to your skin, make sure the Intensity is set at zero or you may feel an initial uncomfortable tingling. Start treatment by gradually increasing the Intensity to the maximum tolerable level and stay at that setting during treatment.
Need help?
Do you have a question about the Solis and is the answer not in the manual?
Questions and answers