Operation - Panasonic EY7881 Operating Instructions Manual

III. ASSEMBLY
EN
Attaching or Removing Bit
NOTE:
When attaching or removing a bit,
disconnect battery pack from the main
unit or place the switch in the center
position (switch lock).
1. Attachment
NOTE:
Precautions for attaching the drill
• When using an old drill bit, for exam-
ple, attachment may not be possible
if its mounting section is deformed.
• Clean the mounting section of the
drill bit and apply grease to it.
(1) Insert a bit into the mounting hole,
and turn it slightly to locate an
engaged position. [Fig.1]
(2) At the engaged position, push the
bit as far as it goes. Make sure that
the bit is fixed by pulling it.
2. Removal
• Depress the chuck cover and pull the
bit. [Fig.2]
Attaching or Removing Battery
Pack
Battery pack fixing
The battery pack is designed to be
installed by proceeding two steps for
safety. Make sure the battery pack is
installed properly to the main body
before use.
1. Attachment
(1) Flip the main unit upside down.
(2) To attach the battery pack:
[Fig.3
Align the highlighted marker points
and attach battery pack.
Slide the battery pack until it locks
into position.
(3) Insert the battery pack until the
battery pack fixing lever catches on
the hook portion of the pack.
[Fig.4
]
]
NOTE:
The overheat warning lamp (H) and the
battery level indicator [E] (J) will flash
when the battery pack is not inserted
firmly.
2. Removal
(1) Flip the main unit upside down.
(2) To remove the battery pack: [Fig.5]
While holding down the the battery
fixing lever,do the following. (
Push the button (
battery pack backward.
IV. OPERATION
WARNING!
• Do not inhale smoke emitted from the
main unit or battery pack as it may be
harmful.
[Main Unit]
CAUTION
When storing or carrying the tool, set the
Forward/Reverse lever to the center
position (switch lock).
NOTE:
Exercise caution to ensure no objects
come into contact with the tool's
trigger switch.
If an object comes into contact with
the tool's trigger switch, even while
the Forward/Reverse lever is in the
center position (locked), a small
amount of electric current may
continue flowing, which may cause an
excessive discharge from the battery
pack and subsequent battery pack
failure.
Switch and Forward/Reverse Lever
Operation [Fig.6]
1. Push the lever for forward or reverse
rotation. Check the direction of the
lever before using.
2. Depress the trigger switch slightly to
start the tool slowly.
- 12 -
)

 ) and slide the