| Installation and user manual | 1. Introduction 1.5 Icons 1.1 Purpose 1.5.1 Icons et notes The Installation and Operation Manual provides Icons used with notes provide additional infor- the necessary information for installing, configu- mation about the note. See the following ring and using an LD serie amplifier.
| Installation and user manual | 1.5 Conversion tables In this manual, SI units are used to express leng- ths, masses, temperatures etc. These can be converted to non-metric units using the following information. Table 1: lenght units conversion 25,40 mm = 25,4 mm 1 mm = 1,00000 25,40 mm = 2,54 cm 1 cm = 0,3937 po...
French market. 2.1 the range The new LD 1.2, 2.2 and 3.2 of the Opus Tech- nologies range are next-generation, French- made magnetic loop amplifiers. The amplifiers, robust, are the most compact on the market while offering the necessary features (AGL, MLC, compressor, ...
| Installation and user manual | 2.4 Safety note The majority of problems with the magnetic in- duction loop (BIM) happens when the installa- tion has not been properly reflected so let's take a little time before starting the installation and gain in result and time.
| Installation and user manual | 3.2 connections 14. Input 1 combo: microphone or line 15. Push button for line or microphone communica- tion of the input 1 16. Push button for line or microphone communica- tion of the input 2 17.
| Installation and user manual | 4. Racking Secure the rack mounting brackets as shown to the right using the mounting screws provided in 4.1 Ventilation and racking the kit. Leave a space of 1U (44mm) above the amplifier Then integrate the amplifier into the bay. Leave a space of at least 168 mm between the bottom of the rack and the amplifier 4.2.2 Integration of two rack amplifiers...
| Installation and user manual | 4.2.3 Integrating an amplifier on a wall Option required: OP-R mounting kit Fasten the brackets as shown in the picture using the screws provided in the kit. Then, attach the amplifier to the desired wall.
| Installation and user manual | 5. Installation 5.1 Two amplifiers LD .2 connection Necessary material : 6.35 Stereo Jack Cable 5.2 For the use of a large coverage system 1. Connect the loop on the terminals provided for this purpose: Loop terminal block of the amplifier 2.
| Installation and user manual | 5.3 LD .2 and LD .0 amplifiers connection Necessary material : 6.35 Stereo Jack Cable 5.2 For the use of a large coverage system 1. Connect the loop on the terminals provided for this purpose: Loop terminal block of the amplifier 2.
| Installation and user manual | 6. Explication Holding and terminating the wire forming the loop are connected to an audio amplifier. The hearing aid has a coil often called "T" or "T-coil" which is placed inside the prosthesis and con- sists of a wire forming turns.
Page 20
| manuel d’installation et d’utilisation | installation and user manual | LD 1.2/ 2.2/ 3.2 For any questions, contact us. OPUS TECHNOLOGIES — ZI LAGRANGE II — 9 Chemin de la Vieille Ferme — 33650 MARTILLAC Tel: 09.81.24.00.06. — Fax: 09.82.63.22.56. — contact@opus-technologies.fr...
Need help?
Do you have a question about the LD Series and is the answer not in the manual?
Questions and answers