Water heater tank and heat pump mixing valve (12 pages)
Summary of Contents for CALEFFI 5335 Series
Page 1
These valves can also be used to control inlet pressure to domestic hot water storage. The Caleffi 5335 series have been specifically designed and manufactured to meet the requirements of “AS1357.2:2005 Valves primarily AS 1357.2 for use in warm and hot water systems - P.
Dimensions Code Mass (kg) 533545 AUS 15 mm 72,5 22,5 Ø 46 0,45 Code Mass (kg) 533555 AUS 533550 AUS 22 mm 72,5 22,5 Ø 46 84,5 0,46 3/4” 72,5 Ø 46 82,5 0,49 ∆p (kPa) 1/2” 3/4” ∆p (m w.g.) Pressure drop diagram Under following conditions: Inlet pressure 600 kPa...
Page 3
MAINS SUPPLY Straight Angle outlet outlet Inlet Outlet Inlet Plug Plug Outlet Line strainer Isolating (where fitted) valve Pressure reducing valve MAINS SUPPLY Check valve System without recirculation Tempering valve STORAGE HOT WATER HEATER COLD WATER INLET...
Page 4
Recommendation for installation conditions When installed upstream of a hot water tank, we recommend installing an expansion vessel or similar equipment to absorb the increase in pressure due to the thermal expansion of the water. When installed in large buildings, adopt technical measures such as using short pipes or including expansion valves and similar equipment to limit the increased pressure due to the thermal expansion of the water caused by temperature changes downstream of the reducing valve itself (or downstream of the first and second stage reducing valves, if two are present).
Installation below ground If installing the 5335 series valve underground, please ensure that steps are taken to protect the valve from becoming frozen in frost-prone areas. Please allow yourself sufficient space to remove the cartridge should maintenance be required.