Advertisement
Quick Links
International
IRP
Refrigeration Products
MEDALLION SERIES
INSTALLATION / OPERATING INSTRUCTIONS
Model: TDMP24-H1-CB
Please refer to the owner's manual for programming instructions.
APPLICATION:
This thermostat is a programmable 24 volt Heating Digital
Temperature Control. It can be used for residential and light
commercial systems. Both models are ideal for use with most
heating systems. The large easy to read display makes the
thermostat easy to operate and simple to program.
The TDMP24-H1-CB is hard-wired and has backlighting for
ease of reading in the dark.
SPECIFICATIONS:
Setpoint Temperature Range: 40.0°F to 95.0°F (5.0°C to 35.0°C)
Display Format:
Liquid Crystal Display (LCD)
Sampling Rate: Every 30 seconds
Accuracy: ± 1°F
Power Source:
24V, 30V maximum AC or DC
Class II Supply and Wiring
Load Rating: 1 Amp maximum total load
Heat Control: 1 heat circuit
General Installations:
This device should be installed and serviced by a qualified
technician. Junction box mounting is highly recommended.
1.
!
Caution: Make sure that power has been disconnected.
2. All wiring must comply with applicable codes and ordinances.
3. A thorough check-out of the system should be made after
installation is complete.
4. If retrofitting old thermostat, remove old thermostat from wall,
carefully noting the wire connections on the old unit. Record
wire color and terminal legends in spaces provided.
Terminal
function
24V Feed
Single 24V Common
Damper (Heat)
Heating
5. Using the mounting screws provided, mount the thermostat to the
wall or junction box.
6. Connect wire cables according to your wire color chart.
7. Push excess cable wires back into the wall while positioning
thermostat. If there is a draft, pack the opening with non-
combustible material.
Cable
Thermostat
terminals
wire color
R
C
B
W
Decrease
Temperature
International Refrigeration Products, Inc.
1035 Wheeler Way
Langhorne, PA 19047
Service:
Monday to Friday
8:00 AM to 4:30 PM EST
Tel: 215-750-9876
1
Heat
Icon
72.3
F
Actual
0
TEMP
Manual
OFF
HEAT
System
Switch
Damper
Heat
Connection
Relay
Stage 1
W
Heat
B
C
R
Supply Transformer
TDMP24-H1-CB
Increase
Temperature
24V Class II
Advertisement
Related Manuals for International Refrigeration Products MEDALLION Series
Summary of Contents for International Refrigeration Products MEDALLION Series
- Page 1 24V Feed TDMP24-H1-CB Single 24V Common Damper (Heat) Heating International Refrigeration Products, Inc. 5. Using the mounting screws provided, mount the thermostat to the 1035 Wheeler Way wall or junction box. Langhorne, PA 19047 6. Connect wire cables according to your wire color chart.
- Page 2 Setting Parameters: There are four parameters to set depending on the model. °F/°C selection, backlight mode selection, display mode selection and cycle rate selection. 72.3 Actual °F/°C Selection: TEMP All units are shipped in °F display mode. °C can be selected by Manual moving the jumper to the °C position.
Need help?
Do you have a question about the MEDALLION Series and is the answer not in the manual?
Questions and answers