Advertisement
Adult assembly required.
Small parts may present choking hazard prior to assembly.
Enclosed please find simple step-by-step instructions to help you
quickly assemble your products. Before you begin we recommend
that you following the steps below:
1. Please read the instructions thoroughly.
2. Identify all parts and hardware.
3. You will need the following tools:
Philips head screw driver
Flat head screw driver
Hammer
Do Not Use Power Drills or Drivers
To protect your parts during assembly please place them on a soft
surface.
To clean surface use only water on a damp cloth. Do not use
window cleaners or cleaning abrasives as it will scratch the surface
and could damage the protective coating.
Please note that the warning sticker is placed on the cribs to keep parents and
caregivers informed it is a requirement by law under CPSC And ASTM.
We do apologize for any inconvenience this may cause you.
BABY TIME INT'L INC
250 PASSAIC ST., NEWARK, NJ 07104
EMILY 2 IN 1 CRIB
STYLE# CRB-400, CRB-401,
CRB-402, CRB-403
s
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Big Oshi EMILY 2 IN 1 CRIB CRB-400
- Page 1 BABY TIME INT'L INC 250 PASSAIC ST., NEWARK, NJ 07104 EMILY 2 IN 1 CRIB STYLE# CRB-400, CRB-401, CRB-402, CRB-403 Adult assembly required. Small parts may present choking hazard prior to assembly. Enclosed please find simple step-by-step instructions to help you quickly assemble your products.
- Page 2 WARNING ! · FAILURE TO FOLLOW THESE WARNINGS AND THE ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. · READ ALL INSTRUCTIONS BEFORE ASSEMBLING CRIB. KEEP INSTRUCTIONS FOR FUTURE USE. ANY MATTRESS USDED IN THIS CRIB MUST BE AT LEAST 51-5/8 INCHES BY 27-1/4 INCHES WITH A THICKNESS NOT EXCEEDING 6 INCHES.
- Page 3 CONNECTION HARDWARE a: 2-1/8” Allen head bolt (10pcs) b: 3/5” Allen head bolt (4 pcs) e: Castors (2 pcs) f: Castors (2 pcs) c: 2”Allen Warench (1pc) d:Barrel nuts (10 pcs) Do Not Use Power Drills or Drivers CRIB COMPONENTS A.
- Page 4 Attach the stationary side (A) to the head board (B) and (C) by using bolts(a) and barrel nuts (d). Then attach the stabilizer bar (E) to the head board (B) and (C) by using bolts(a) and barrel nuts (d). Locate the metal spring (D) with tabs.
- Page 5 Attach the stationary side (A) to the head board (B) and (C) by using bolts(a) and barrel nuts (d). Insert the four casters (e&f) as shown and tighten all bolts. Inspect the crib to make sure it is assembled correctly and all bolts are tight. FLAT HEAD SCREWDRIVER WRENCH FLAT HEAD SCREWDRIVER AND...
- Page 6 CONVERT THE CRIB INTO A DAY BED You have the option to convert crib to a day bed 1.Remove the stationary side (A) near the stabilizer bar by using Allen warench (c). 2.Install the mattress support (D) in its lowest position. 3.Remove the casters.
Need help?
Do you have a question about the EMILY 2 IN 1 CRIB CRB-400 and is the answer not in the manual?
Questions and answers