Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Podab KM 752
- Page 1 Installation, operation manual and spare parts list Cold ironer KM 752...
- Page 2 Thank you for choosing the cold ironer KM 752 from PODAB. We hope that it will be of great use for you and ask you kindly to read the instructions carefully. IMPORTANT! FOR YOUR SAFETY: the information in this manual must be followed to prevent property damage and personal injury.
-
Page 3: Table Of Contents
Clean the cold ironer Replace the iron cloth Control the oil level User manual Controls Before you start Start Stop Reverse/release When you are finished Cold ironing techniques If the cold ironer stops Spare parts list Electrical drawing Notes ©PODAB 2018... -
Page 4: Safety Regulations
Common sense, caution and care must be exercised when installing, maintaining, and operating the cold ironer. Always contact your dealer, distributor, service agent or the manufacturer about problems or conditions you do not understand. ©PODAB 2018... -
Page 5: Installation
Technical information Before you start Tools Roller width, mm You need the following tools to easily install the cold ironer Roller diameter, mm KM 752: Roller speed, v/min • Cross head screwdriver Roller pressure, kg/cm² • Wrench Iron cloth length, mm 2500 • Level... -
Page 6: Installation Of The Cold Ironer
NOTE: The machine must be connected in the correct phase sequence in order to start. KM 752 is equipped with a phase sequence protection relay. A green light will be lit on the relay when the sequence is correct. -
Page 7: Maintenance
Fit the new iron cloth in the slot with the hem facing the rear of the cold ironer. Reinstall the top cover and turn on the power. Place the manoeuvre shield in the position, START/FORWARD and roll up the new iron cloth. ©PODAB 2018... -
Page 8: User Manual
Reverse/release - Stop - Start/forward Finger Reverse/release protection REVERSE Motor protection If the motor is overloaded it will stop. Press the button for over- load protection to restart the motor. Stop Reseting of motor overload protection STOP ©PODAB 2018... -
Page 9: Before You Start
Do not reach for or touch the rollers when they are mov- ing or when they are stopped. - Risk for severe squeezing. STOP Do not allow children to play on or around the cold ironer. DO NOT bypass any safety devices. FORWARD ©PODAB 2018... -
Page 10: Spare Parts List
Spare parts list ©PODAB 2018... - Page 11 Shaft 7534 Belt pulley 7593 Spring 7594 Spring 7595 Support 7596 Roll support left 7597 Roll bushing 7598 Micro switch 7599 Roll support right 7560 Micro switch 7561 Support 7562 Motor support 7515 Motor, including gearbox 7563 Support ©PODAB 2018...
-
Page 12: Electrical Drawing
Electrical drawing ©PODAB 2018... -
Page 13: Notes
Notes ©PODAB 2018... -
Page 14: Podab
©PODAB 2018... - Page 15 ©PODAB 2018...
- Page 16 SERVICE/SUPPORT Phone +46 31-752 01 00 +46 31-752 01 50 E-mail parts@podab.se www.podab.se AB PODAB, Ekonomivägen 9, 436 33 Askim, SWEDEN Tel +46 (0)31-752 01 00, Fax +46 (0) 31-752 01 50 E-post: sales@podab.se, www.podab.se ©PODAB 2018-08-15...
Need help?
Do you have a question about the KM 752 and is the answer not in the manual?
Questions and answers