fengMi Wemax One User Manual

FengMi Wemax One Laser Projection TV
To user
Thank you for choosing the FengMi Wemax One Laser Projection TV multimedia
projector.
Before using the device, please read this instruction manual carefully and keep it properly
for future use.
Laser safety information
This device is equipped with Class 1 laser equipment, that meets the requirements (Class
1 laser equipment) IEC 60825-1: 2014, CFR 1040.10 and 1040.11, and is not a source of
hazardous laser radiation.
Safety information
Before using the device, please read carefully all the safety requirements and
recommendations on the labels and/or labeling of the device.
Significance of warning signs
This sign indicates that there are uninsulated wires in the device housing, that
can cause electric shock and any contact with it creates a risk of injury.
Attention! Heat.
This sign reminds the user to pay attention to important information about
the rules of use and maintenance of the device. Please read this information
carefully to avoid damaging the projector.
Do not touch by hands.
User`s Manual
About electrical ground
Use this device only with a compulsory grounding condition.
Transportation
It is recommended that you use the original packaging or similar material to
transport this device safely.
Prevention of electric shock and / or fire
- The use of unreliable electrical cables can affect the performance and
characteristics of the device. In addition, this may result an electric shock, fire,
or other accidents. To avoid the above situations, we recommend to use original
electrical cables, or cables of the same type.
- If you need to use an extension cord, select a cable, whose rated current is not less than
the rated current of the device. Ignoring this recommendation may result an overheating of
the power cord, that can cause electric shock or fire.
- During lightning or if the device is not used for a long time, please remove the plug
from the outlet. This way you will avoid damage to the projector, which can occur due to
lightening or overvoltage of power lines.
- Do not leave flammable objects near this unit to avoid a fire.
- Do not cover the lens of the device with foreign objects while it is operating. This can
lead to lens heating, deformation and even fire.
- Do not leave foreign objects near the ventilation openings and air circulation holes (heat
dissipating holes). This can lead to the accumulation of heat inside the device or even the
occurrence of a fire.
Safety regulations
- Do not install the unit on unstable surfaces, tables or other supports to avoid falling,
damaging or injuring others.
- Do not look directly into the lens or into the air circulation holes (heat dissipating holes)
during operation, in order to avoid eye injuries.
- Do not disassemble the device by yourself. Inside the device there is a high voltage, on
contact with which you can be injured. If there is a need for maintenance or a complete
repair of the device, be sure to contact the appropriate authorized service center.
- Do not install the device in a vertical position, otherwise it may fall or injure others.
- Avoid getting the product in the rain and do not leave it in a damp environment (the
operating humidity of the device is between 20% and 80%).
- Do not immerse the device in water and avoid water or other liquids. If any foreign object
or liquid enters the device, immediately disconnect it from the power supply and contact
an authorized service center for technical inspection. Only after this you can use the
device again.
- Do not install the device:
• in places with poor ventilation or air circulation or in very tight places;