715 Center Street Grayslake IL 60030 P: 847-752-2700 F: 847-752-2415 E: info@livorsi.com GPS SPEEDOMETER INSTALLATION Mega and Race Series, Industrial Series Models PART # GPSS and GPSL all colors Antenna Placement If you are using the supplied antenna, find a mounting location that will maintain an unobstructed view of the satellites.
Page 2
Back of GPS Speedometer Recall Switch Wiring 1. Find a suitable location for the recall switch, drill a 1/2" opening in the panel. 2. Center the opening in the panel with the opening on the cover plate, and mark the centers for the screws that will secure the cover plate to the panel.
Page 3
Gauge 1. Cut out a 4 5/8" (117 mm) opening in the dash board for a GPSL series gauge Or a 3 3/8" (86 mm) opening for a GPSS series gauge. 2. If possible, slide the wiring harness through the opening and make all the electrical connections prior to fitting the gauge in to the panel.
Page 4
Operation When the gauge is powered up and the antenna is properly connected, it will go through a self test mode. During this period • the pointer will move to 3 o'clock position • then immediately sweep to the 12 o'clock position •...
Page 5
Possible Causes: Lost antenna connection, damaged antenna or lost satellite signal. Remedy: Verify antenna connections. If correct, and relocation of the vessel does nothing, replace antenna. For technical support please call the Livorsi Marine, Inc. office at 847-752-2700 or email info@livorsi.com REV A...