Advertisement
Quick Links
GPS SPEEDOMETER INSTALLATION
Mega and Race Series, Industrial Series Models
PART # GPSS and GPSL all colors
Antenna Placement
If you are using the supplied antenna, find a mounting location that will maintain an unobstructed view of
the satellites.
Hidden installation of the antenna is possible and can be determined by temporarily mounting the
antenna in the desired location and checking the signal.
Due to the differences in dash or deck thickness and materials, results are difficult to predict. The signals
will not pass through metal, but may pass through glass and plexi windshields.
Additionally, try to keep the antenna away from any aluminum or stainless frames.
1. Once a location is chosen, drill a 3/8" (9.5 mm) opening in the mounting panel.
2. Slide the antenna cable in to the opening and secure the antenna with a screw or double sided tape.
If you are using an alternative antenna, make certain that its NMEA 0183 and that the wiring is
compatible with the gauge.
Wire Connection
White
Signal
(NMEA 0183 output)
Red
Switched 12V power
Black
Good engine ground
LIT-GA-ANLG-GPS
REV A
ECO 28610
715 Center Street
Grayslake IL 60030
P: 847-752-2700
F: 847-752-2415
E: info@livorsi.com
1 OF 5
Advertisement
Summary of Contents for Livorsi Mega Series
-
Page 1: Wire Connection
715 Center Street Grayslake IL 60030 P: 847-752-2700 F: 847-752-2415 E: info@livorsi.com GPS SPEEDOMETER INSTALLATION Mega and Race Series, Industrial Series Models PART # GPSS and GPSL all colors Antenna Placement If you are using the supplied antenna, find a mounting location that will maintain an unobstructed view of the satellites. - Page 2 Back of GPS Speedometer Recall Switch Wiring 1. Find a suitable location for the recall switch, drill a 1/2" opening in the panel. 2. Center the opening in the panel with the opening on the cover plate, and mark the centers for the screws that will secure the cover plate to the panel.
- Page 3 Gauge 1. Cut out a 4 5/8" (117 mm) opening in the dash board for a GPSL series gauge Or a 3 3/8" (86 mm) opening for a GPSS series gauge. 2. If possible, slide the wiring harness through the opening and make all the electrical connections prior to fitting the gauge in to the panel.
- Page 4 Operation When the gauge is powered up and the antenna is properly connected, it will go through a self test mode. During this period • the pointer will move to 3 o'clock position • then immediately sweep to the 12 o'clock position •...
- Page 5 Possible Causes: Lost antenna connection, damaged antenna or lost satellite signal. Remedy: Verify antenna connections. If correct, and relocation of the vessel does nothing, replace antenna. For technical support please call the Livorsi Marine, Inc. office at 847-752-2700 or email info@livorsi.com REV A...