Table of Contents
Advertisement
Note:
After powering, the device outputs
0.00 mA or 0.00 V. The Auto function
does not start automatically.
Alter the manual start of the Auto
function, the device outputs the
value ou.1. After the execution of the
cycle, the output remains with the
value ou.1.
Complements to points 4.2.2 and
4.2.3
1. If YES was selected for
the display can show a value dif-
ferent from the value of the output
setpoint.
2.The function SPecial disPlay
A
–
The function
SPecial.decimalPoint allows defi-
ning the number of decimal places
(only for the values appearing on
the display).
–
display.Low allows
defining the minimum value to be
displayed. This value corresponds
to the value ou.Lo used for the
www.kep.com
to
output setpoint.
–
defining the maximum value to be
displayed. This value corre-
sponds to the value ou.Hi used
for the output setpoint.
Example:
The display must show 10 (kg) while
the setpoint output must be 2 V
(lower limit value); the display must
show 40 (kg) while the setpoint out-
put must be 8 V (upper limit value).
,
7
D
6
A
8 V
2 V
10 kg
3. Press both keys to resume pro-
gramming at point 4.2.1 (1). SiGn,
see A in the flow chart
⇑
⇑
Summary:
Display
When programming, the values for
the display and for the output set-
point are linked together.
display.High allows
40 kg
Output value
9
Advertisement
Table of Contents
