Related Manuals for Kessler-Ellis Products IEPS 3000 Series
Summary of Contents for Kessler-Ellis Products IEPS 3000 Series
- Page 1 IEPS 3000 Series UICK TART UIDE KESSLER-ELLIS PRODUCTS 10 Industrial Way East Eatontown, NJ 07724 800-631-2165 • 732-935-1320 Fax 732-935-9344 http://www.kep.com 99872 03/25/03...
-
Page 2: Assigning An Ip Address
IEPS Quick Start This manual summarizes steps you can follow to quickly set up and use your port server after the hardware installation (documented in the Hardware Manual provided with your port server). It describes the default settings which allow you to begin using the server almost as soon as you remove it from the box. - Page 3 Assigning the IP Address via Terminal 1. If you connected a terminal, the “Welcome” banner and a password prompt will appear on your terminal. The factory-supplied user password is “user”; the administrative password is “admin”. Enter administrative mode, so you can assign an IP address to the port server: Welcome to the port server Remote Communications Server Password:user...
- Page 4 For Windows, if more than one network adapter is configured, the interface address must be used with the arp -s command. If the interface address is not used, the arp command cannot distinguish which interface is being referenced, causing the command to be discarded without executing, with no error message returned.
- Page 5 5. Reset the port server either by cycling power or by entering “expert” mode and issuing the reboot command: admin>> expert expert>> reboot 6. When the port server has rebooted, log in again by repeating step 1 above. You can establish telnet or rlogin sessions with other hosts on your network via any of the serial ports on the port server using commands available “user”...
- Page 6 Quick Configuration Reference After assigning an IP address to the port server, you can configure it for your applications. You can configure it by using a terminal attached to one of its serial ports, by conneting to it via telnet, or by using a web browser. Table 2-1 summarizes some of the commonly changed configuration items.
Need help?
Do you have a question about the IEPS 3000 Series and is the answer not in the manual?
Questions and answers