Download Print this page

Binatone MC-SM1020 User Manual

10/100m media converter

Table of Contents

Download this manual

Enlarged version

10/100M Media converter series

USER'S MANUAL

MC-SM1020

Copyright statement

This publication may not be reproduced as a whole or in part, any way what

so ever unless prior consent has been obtained from us.

The 10/100M series media converter have been tested and found to comply

with the limits for a Class A digital device, pursuant to Part 15 of the FCC

Rules. These standards are designed to provide reasonable protection against

harmful interference when these devices are operated in commercial

Table of Contents

Do you have a question about the MC-SM1020 and is the answer not in the manual?

Page 1 MC-SM1020 Copyright statement 10/100M Media converter series This publication may not be reproduced as a whole or in part, any way what so ever unless prior consent has been obtained from us. FCC warning The 10/100M series media converter have been tested and found to comply USER’S MANUAL...
Page 2 environment These devices can use, generate and radiate radio frequency operation status easily via a set of LED located in the front panel. energy and may cause harmful interface to radio communications unless Package Content installed in accordance with this User’s Guide. Operation of this device in a MDI-MDIX Auto-crossover supported residential area is likely to cause harmful interface which will make the user Support flux controlling of full duplex/backpressure of half duplex...
Page 3 No connection RJ-45 part x 1 (10/100 Mbps) INTERFACE SC/SFP connector Fiber port x 1 (100 Mbps) A valid network connection established on Fiber port Full Speed 10/100BASE-T:UTP Category 5, 5E CONNECTIONS half Speed 100BASE-SX:62.5/125µm 100BASE-LX:9 or Flash Fiber Data FIBER or 50/125µm Multi-mode 10/125µm Single-mode...
Page 4 4-ON 5-OFF, straightforward mode Typical 550m/220m 20Km 40Km 60Km 80-100Km 6．LFPT function：ON-open；OFF-close Distance Optical ≥-12dBm ≥-14dBm ≥-11dBm ≥-6dBm ≥-5dBm Notice: when start up LFPT function, please pay attention to set the DIP switch power 6 to “ON” firstly, then power on the product. ≤-23dBm ≤-34dBm ≤-36dBm...