Blue - LDDE NanoPix Cyc Short Instruction

Settings
PWM frequency
Changes to the PWM frequency can be performed here.
The possible settings can be found in the table below.
750 Hz
1500 Hz
3000 Hz
Quiet Mode
The Quiet Mode is designed for noise-sensitive applications, for this purpose the fans can be switched on and off.
The stepless regulation of the fans is monitored with a temperature sensor.
OFF
ON
Manual Mode
In manual mode, the NanoPix Cyc can be set to any color, including strobe.
The NanoPix Cyc is then in the Ch7 - Normal Mode and the following settings can be made directly in the
menu using the selection keys.
I
R
G
B
WW
CW
St
LDDE Vertriebsgesellschaft GmbH reserves the right, without prior notice, changes to the product and specification
PWM frequency 750 Hz
PWM frequency 1500 Hz
PWM frequency 3000 Hz
The fans are switched on from a temperature of 40°C and
controlled depending on the temperature.
From a temperature of 56°C, the brightness is also adjusted.
When the Quiet Mode is activated, no fan is used,
the maximum brightness is limited to 70%.
If the measured temperature exceeds 79°C, the fan is switched on
for safety reasons in order to avoid damage to the device.
Intensity between DMX value 0-255
Red of DMX value 0-255
Green of DMX value 0-255
Blue of DMX value 0-255
Warm white of DMX value 0-255
Cold white of DMX value 0-255
Strobe of DMX value 0-255
DMX value 0-25 no Strobe
DMX value 26-228 - Strobe frequency from 1Hz to 25Hz
DMX value 229-255 no Strobe
Lighting LDDE Vertriebsgesellschaft m. b. H.
Design Simmeringer Hauptstraße 357, 1110 Vienna, Austria
Development P: +43 1 7671811 0, F: +43 1 7671811 99
Electronics E: office@ldde.com; W: www.ldde.com
Page 7