Summary of Contents for Woodie's 1153279
- Page 1 LAWN MOWER OWNER’S MANUAL Woodies SKU: 1153279 & 1153280 CAUTION: Read and follow all Safety Rules and Instructions before operating this equipment Thank you for choosing our Gasoline Lawnmower.
-
Page 2: Table Of Contents
To ensure that you get the best results from your Gasoline Lawnmower please read all of these safety and operating instructions carefully before using this product. TABLE OF CONTENTS 1. Safety Messages………………………………………………….. 2. Assembly……………………………………..….……………… 3. Before Operation……………………………..…………………..4. Operation……………………………………..…………………… 5. Maintenance………………..……………..……………………… 6. -
Page 3: Safety Messages
Your safety and the safety of others are very important. We have provided important safety messages in this manual and on the mower. This information alerts you to potential hazards that could hurt you or others. Please read these messages carefully. Of course, it is not practical or possible to warn you about all the hazards associated with operating or maintaining a lawn mower. - Page 4 Using Instructions Check that all nuts, bolts and screws are well tightened. Before mowing place the grass catcher in its position. Before mowing make sure that the blade and the blade fixing screw are securely fastened. When cutting edges require resharpening, this must be done evenly on both sides so as to prevent any imbalance.
-
Page 5: Assembly
from the one where gasoline have been split and avoid any contact from a hot source as long as the split gasoline is completely eva0porated. Tighten the fuel tank cap and close tightly the jerry can cap. Assembly Unpacking Remove lawn mower from carton and check thoroughly for additional loose parts. Handle Setup And Height Adjustment Open out the handle and screw the handles parts with the four screws and knobs. - Page 6 Bracket to fix the handle bar with screws and knobs. The “H” hole is high position of the handle bar, and the “L” hole is low position of the handle bar. Brake Cable Setup Put the brake cable and Clutch cable to the hole of brake lever and Clutch lever. (see the arrow mark) Brake Cable Clutch Cable...
- Page 7 Take out panel and two screws in a bag from carton, and fix the panel with screws. SCREW CONTROL PANEL Bolts PANEL * Note: Not all models do have middle Panel. Grass Bag Assembly Slide the grass bag frame into the grass bag and attach the clips as shown.
- Page 8 Lift the rear discharge guard, remove the mulching plug, and install the grass bag. Mulching plug The mulching plug helps to curve the inside of the mower deck for more efficient mulching.
- Page 9 Install and remove the mulching plug by raising the rear discharge guard as shown. The mulching plug only fits one way. Remove the mulching plug when using a grass bag. Rear Discharge Guard Props Take out two supports in a bag from carton, and lift the rear discharge guard, install the two supports which can hold the rear discharge guard, and this can make the grass out more efficiently from the deck.
-
Page 10: Before Operation
Only Mulching: please remove the side discharge cover. * Note: Not all models do have side discharge guard 4. Before Operation Engine Oil The mower is shipped without oil in the engine. All engines are run at the factory prior to packaging. Most of the oil is removed prior to shipment; however, some oil remains in the engine. - Page 11 NOTICE: Engine delivered without gasoline, refuel 1.0 liter of before starting the engine. Remove the filler cap Add fuel to the bottom of the fuel level limit in the neck of the fuel tank. Do not overfill. Wipe up spilled fuel before starting the engine.
-
Page 12: Operation
5. Operation Starting The Engine Primer (Only for G46P-B, G46SHL-B) In cold condition, it’s necessary to push the primer button on the air filter before pulling the starter handle. Primer only for cool engine use Temperature Push time <0℃ 0℃~10℃... - Page 13 BRAKE LEVER Release the clutch lever. This will prevent the mower from moving forward when you operate the starter. CLUTCH LEVER * Note: Not all models have this clutch lever. With the starter handle in its support, take the starter handle with your right hand and pull slowly as far as to have a resistance, then pull energetically on the starter handle with starter rope through the support.
- Page 14 “CHOKE” position to “RUN” position.(If the temperature is low, allow the engine to run for a few minutes before starting to work.) * Note: Not all models have this choke lever. (Only for model G53SHL-C) Operation The Controls For Mowing Blade is in action as soon as engine started.
- Page 15 Throttle Lever For best cut quality, always mow with the throttle lever in the “FAST” position. When the blade rotate at the preset fast speed, it creates a strong fan action that lifts and cuts grass more efficiently. FAST * Note: Not all models have this Throttle lever.
-
Page 16: Maintenance
Release the brake lever. BLAKE LEVER The blade will continue to rotate for a few seconds after the engine has stopped. Disconnect the spark plug cap if the lawnmower is to be left unattended. 6. Maintenance IMPORTANT Regular, careful maintenance is essential for keeping the safety level and original performance of the machine unchanged in time. - Page 17 Inspection Tilt the mower to the right, so the air cleaner side is up. This will help to prevent fuel leakage and hard starting. Inspect the blade for damage, cracks and excessive rust or corrosion. A dull blade can be sharpened, but a blade that is excessively worn, bent, cracked, or otherwise damaged must be replaced.
- Page 18 Cleaning Wash the bag with a garden hose, and allow it to dry completely before use; a wet bag will clog quickly. Replacement Unclip the plastic edges of the bag from the frame, remove the frame from the bag. ...
- Page 19 down a drain. Fill with the recommended oil. Do not overfill. Allow a couple of minutes for the oil to settle in the engine, then measure the oil level. Air Cleaner Service NOTICE: Operating the engine without an air cleaner, or with a damaged air cleaner, will allow dirt to enter the engine, causing rapid engine wear.
- Page 20 Remove the spark plug with a spark plug wrench. Inspect the spark plug. Replace it if the electrodes are worn, or if the insulator is cracked or chipped. Measure the spark plug electrode gap with a suitable gauge. The gap should be 0.028 ~ 0.031 in (0.7 ~ 0.8mm).
- Page 21 lever were loose, you should turn the brake cable adjustment to tighten. (please see the picture) Maintenance Schedule REGULAR SERVICE Before First Every 3 Every 6 Every Every PERIOD(4) Each Month Months Months Year Years 5 Hrs 25 Hrs 50 Hrs 100 Hrs or 250 ITEM...
-
Page 22: Storage
ENGINE WILL NOT START Possible Cause Correction 1. Check fuel. Out of fuel. Refuel Bad fuel; engine stored without Drain the fuel tank and treating or draining gasoline, of carburetor. Refuel with fresh refueled with bad gasoline gasoline. 2. Remove and inspect spark Spark plug faulty, fouled, or Replace the spark plug.
Need help?
Do you have a question about the 1153279 and is the answer not in the manual?
Questions and answers