1. Manuals
  2. Brands
  3. APURO Manuals
  4. Meat Grinder
  5. CD400-A
  6. Instruction manual

APURO CD400-A Instruction Manual

Hide thumbs Also See for CD400-A:
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
Meat Grinder
Instruction manual
Model
CD400-A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CD400-A and is the answer not in the manual?

Questions and answers

Related Manuals for APURO CD400-A

Summary of Contents for APURO CD400-A

  • Page 1 Meat Grinder Instruction manual Model CD400-A...

  • Page 2: Safety Tips

    Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities. • If the power cord is damaged, it must be replaced by a Apuro agent or a recommended qualified technician in order to avoid a hazard. Introduction Please take a few moments to carefully read through this manual.
  • Page 3 Telephone Helpline: 1 888 747 1447 Assembly Insert the mincing barrel into the motor housing mouth, with the hole facing upwards [Fig. 1]. Tighten the locking knob [Fig. 2]. Insert the feed screw in to the mincing barrel. Turn the screw slightly to slot the base of the screw on to the transmission shaft, if necessary [Fig.

  • Page 4: Operation

    Operation Note: Clean the appliance with warm soapy water and dry thoroughly before using for the first time. Cut the meat into small enough pieces to fit in to the hole in the hopper tray. Turn the power switch ON. Feed the meat into the shaft using the food pusher.

  • Page 5: Cleaning, Care And Maintenance

    Always dry thoroughly after cleaning. • Lubricate the parts with a little cooking oil before replacing for best performance. Troubleshooting If your Apuro appliance develops a fault, please check the following table before making a call to the Helpline. Fault Probable Cause...

  • Page 6: Technical Specifications

    All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of Apuro. Every effort is made to ensure all details are correct at the time of going to press, however, Apuro reserve the right to change specifications without notice.

  • Page 7: Declaration Of Conformity

    DECLARATION OF CONFORMITY Equipment Type Meat Mincer Model CD400-A Legislation C-Tick AS/NZ 3820 Essential Safety Requirements for Low Voltage Electrical Equipment Standards AS/NZS CISPR 14.1:2010 AS/NZS 60335.1:2002 IEC 60335-2-64:2000+ Annex ZZ of AS/ NZS60335.1:2002+A3 Producer Name Apuro Producer Address 15 Badgally Road,...
  • Page 8 CD400-A_v2...

Table of Contents