Advertisement
• Upon use of your BT-200 the volume must be adjusted to your desired level, as the volume level has been pre-set to the maximum. ( 30% initial volume setting)
• Your device will automatically find and pair with the BT-200 after the initial pairing. If your device does not automatically pair within 5 minutes, the BT-200 switches off. You
can switch on the headset and repeat steps 1-4.
• The BT-200 will automatically pair to the last device connected.
• The volume up/down buttons on the BT-200 may control the volume on your device.
Device's results may vary.
Cable management
To loosen the removable cable management clip.
Troubleshooting
Issue: My BT-200 doesn't turn on.
Solution: Try the following:
• Make sure the BT-200 is charged.
• Make sure the volume is turned up on your device and the BT-200.
• Make sure you press and hold the power/phone button for at least 5 seconds.
Issue: My BT-200 is not charging.
Solution: Try the following:
• Make sure the charge cable is fully inserted in the BT-200.
• Make sure that the charge port on the headset is free from dust and debris.
• Make sure that you are using the charge cable that came with your BT-200.
• Make sure there is power coming from the power source.
Issue: My BT-200 isn't syncing to Bluetooth.
Solution: Try the following:
• Make sure you hold the power/phone button down until you hear a voice say "Ready for pairing"
after it says "Power on".
• Make sure that the Bluetooth setting is turned "on" on your device.
• Check to see if another user is connected to the BT-200.
• Refer to the user guide of your device for Bluetooth syncing instructions.
Issue: My BT-200 volume is turned all the way up, but the volume is still very low.
Solution: Try the following:
• Make sure your BT-200 and audio device are charged.
• Make sure the volume is turned up on your device and the BT-200.
Issue: The person on the other line cannot hear me very well.
Solution: Try the following:
• Make sure your BT-200 and phone are charged.
• Make sure there is nothing covering the microphone on the control box.
• Make sure you have service with your phone provider.
Safety warning
• Do not listen at a high volume level. Extended high volume levels can lead to permanent hearing loss.
• Start with setting the volume level at the lowest volume and adjust until you reach
a comfortable volume level.
• Tampering or removing the battery can result in damage to your product, void of warranty,
and could cause injuries.
• Do not use when a failure to hear your surroundings could be dangerous, such as while driving, or when biking, walking or jogging where traffic is present and accidents may
occur.
• Do not use while sleeping, as accidents may occur.
• If you experience any ringing in your ears, try lowering the volume. If the ringing persists,
visit your physician.
Important safety precautions
• Incorrect use or incompatibility with your device may result in reduced battery performance or damage to your device.
• Do not attempt to disassemble product.
• Tampering or removing the battery can result in damage to your product, void of warranty, and could cause injuries.
• Do not allow this product to have contact with liquids.
• Store and operate between 32°F – 113°F.
• Do not place this product near a heat source or flame.
• Do not throw or shake.
• Do not operate if it has been subjected to shock or damage.
• Do not crush or puncture the battery.
• Recharge the battery every 3 months when not in use to keep battery in best condition.
Advertisement
