YDI Marquee Bridge 49 Quick Start Manual

Introduction
The Marquee Bridge 49 (MB-49) is a complete 4.9 GHz
wireless point-to-point (p-p) or point-to-multipoint (p-mp)
system that links two Ethernet LANs together. It consists
of two high-gain directional antennas and a pair of
OFDM radios in a rugged outdoor enclosure. They
connect to the LAN's Ethernet Switch on each end with
an outdoor-rated Ethernet cable ordered separately. It is
ideal for connecting two office LANs together, or for
linking a WIPOP site to an Internet backbone. The
Marquee Bridge 49 uses TurboCell software which
supports VLAN bridging (802.1q protocol).
The Marquee Bridge 49 will accommodate virtually an
unlimited number of client MAC addresses on each side
of the link. The unit currently supports a single channel.
Marquee Bridge 49 Kit Contents
1. Two outdoor radios with RF connector for external
antenna and mounting hardware
2. Two Cat 5 DC Power Injectors (surge protected
Power Injectors are available as an option)
3. Two 110/240 VAC to 48 VDC power supplies
4. Windows -based YDI Configurator software
5. Two 3 foot low-loss coaxial cables
6. Two high-gain directional antennas
YDI EtherAnt outdoor Ethernet cables must be ordered
separately. Available lengths are 50, 100, 200, or 300 ft.
Figure 1 – Marquee Bridge 49 Kit Contents
1
The Marquee Bridge 49 is intended for professional
installation only on fixed outdoor structures. Please
review the entire manual before powering up or
deploying these units.
Installation
NOTE: All connectors must be properly water-proofed
with all-weather electrical tape, Permagum, or
equivalent. Do not use Silicon glue.
The Marquee Bridge 49 radio unit is installed by means
of a pole mount adaptor bracket that is secured to the
pole using two metal hose type clamps. Figure 1 shows
the hardware provided to mount the outdoor RF Unit.
1. Install the outdoor unit pole mount adaptor bracket
using the supplied metal hose type clamps (see
Figure 2).
MNL-500267-001 – Rev ED2
PRELIMINARY
Figure 2 – Detail Showing Outdoor Unit Pole Mount
2. Align the four mounting studs on the outdoor unit
with the bracket holes (see Figure 3) and secure to
the bracket by pushing down the latches as shown
in Figures 4a and 4b.
Figure 3 – Attaching the Marquee Bridge 49 Outdoor
2
3
3
2
Figure 4a – Latching Bracket to Pole Mount
1
Marquee™ Bridge 49
Quick Start Guide
Bracket
Unit to the Pole Mount Bracket
Aug 2004